开云体育

Yaesu HT w/ CTCSS - Tone enabled Duplex type - 1 half duplex hotspot thanks [email protected]> wrote:

The settings look fine. Are you sure you have CTTS enabled on your HT? What mode did you select in ASL3 setup?? It needs to be duplex=1 in rpt.conf

I am unable to connect to SHARI (Pi4)ALS3 node with HT.? Brand new (device), install of ALS3, on new sd card.? I can receive from the node to HT.? My settings are listed below....... Thanks 73

https://github.com/jgedde/Allstar-Node-LCD?fbclid=IwAR26Iqcz3LTacDZi7pJwOIlabjFgs0uXFBv2DIdGj5QmoZrZnb9DlT1BNwc This works! I've used it myself on hamvoip image wrote:

Ken, I’m in agreement with you on your points you mentioned. It doesn’t need to be flashy, just something simple with information that you mentioned. Dennis - KD9ULM

I like small displays on pi-star hotspots (0.96") so I can confirm it's on, running normally, internet connected, and what the ip address is. This is most important on a hotspot I may move between

Such a display could essentially show the same info that is available in Supermon, Allmon, or lsnode. If it were a nextion it would be possible to also enable simple commands like link and unlink. ?I

I am using that LCD. 73 Svxlink Remote Display fm-funknetz.de

Hello Dennis, i am unsing that kind of LCD. But only a 2x16LCD. That shows me the connected TG and if its Online or not. 73 de OE9SAU https://fm-funknetz.de/svxlink-remote-display/

Dennis, It's not my idea, I just fleshed out what Jeff mentioned. There is no 'contact info' to share, since there are no DMR IDs nor a database to query, so all it could really display is SHARI

I was thinking hamvoip. That runs a web server. [email protected]> wrote:

Ken, I would like to see that! Would it be on a 3.5 inch display? It sounds like it would look similar to the Zumspot Elite. 73’s -- Dennis - KD9ULM

Does the software support small (or any) displays? What would you want it to display? System stats (IP, temp)? Nodes linked to? There is no 'who's transmitting' info to display... After IP, temp, and

I was wondering if anyone has used a small lcd display for there Shari node. ?Maybe in a 3d printed case?

Fingers crossed I think I got it. Not sure where the RF is coming from but I switched to dcs and so far that seems to have fixed the probably. [email protected]> wrote:

There is a DMR VHF Repeater a block away from me, used by Local Police I catch occasional front end overload from it from time to time. That’s why my home AllStar node is 70cm ;-) Fred McGuire -

I had my node connected to a local repeater on allstar and got booted because it kept keying that system... Interested to see what fixes it.. Also if you have any additional installation software (ie

That is a digital (dmr, fusion, d-star) transmission.? Do you have a mmdvm node at your location on the same frequency (or nearby frequency that might be overloading the frontend of the SHARI

Colin, Are you running ASL 2 or ASL 3? Dean - KC9REN

Colin, I just watched Freddie Mac's video about this last night.? Here a link.? He's got a ton of informative videos out there on Allstar nodes. ?https://youtu.be/odYKcSzUqpE?si=uCNUVpC0zkYtzUAj