开云体育

I had to reinstall ASL 3.0 and am able to get the allstar node with a good connection to the allstar server. There are two areas I am having issues with 1) Where do I test my DTMF settings? When I do

N8AR <n8ar73@...> added folder */How To* *Description:* This folder contains various documents explaining how to do certain tasks related to a SHARI node.

On the SHARI's it is actually done by software.? Here is a link to a thread on arm-allstar that explains how it works in more detail.

Hello Larry, As you had indicated you're running Supermon, I'll assume that you're running HamVoIP? Given this assumption, log into your HamVoIP node via SSH as root. Hopefully you still have these

Cause the cos is not detected by the software it is detected be the hardware wrote:

Are you running hamvoip or asl? wrote:

As you may already know, the method to illuminate the COS LED using a GPIO pin on the CM108 is in theHamVOIP image (commented out) but not in the new ASL3 image.

I am wondering why that the setting for led cos is not in the rpt.conf as an option within the image download file? K6DLC

Hello All! I recently had a hard drive 'crash' (SSD). I had saved what I "thought" was sufficient data to restore files, programs, passwords, etc. Having slowly gotten most of what I want/need, I

Did you make sure the IAX port on the AllStar Link is correct? You need to login, click on Portal, then Server Settings. Then you click on the node number you are working on. It will look like this.

The following files and folders have been uploaded to the Files area of the [email protected] group. * /SHARI PiHat Mod2 52Pi case Documentation/How to enable the COS LED for ASL3 Alllstar Image.pdf (

Ooops, I replied to the wrong email. Download the ASL3 appliance image and flash the card with the raspberry pi imager. Don’t forget to set the username and wifi and enable ssh in the imager. It’s

Download the ASL3 appliance image and flash the card with the raspberry pi imager. Don’t forget to set the username and wifi and enable ssh in the imager. It’s debian 12.7 -Michael Sent: Friday,

Hi I'm trying to install shari on deb 12 can someone help me please

Hi If you talking about number 4 on? tx b? no it's not use just tx a I'm belive

You are correct.? In a SHARI node, the transmit (TX) audio comes from pin 30 of the CM108B (Line Out Left or LOL).? This is commonly called *Transmit A Level, TXA* or *TX-A*. Pin 32 - Line Out Right

I always thought TX-B wasn't used... unless something's changed in the last few years.. Bob KK6RQ

Two nodes on the same LAN behind a router usually will not connect unless the router has "hairpin" capability. Here is a link to more information about this.? Click on "Next Message" to follow the

Have you tried a port checker? https://canyouseeme.org/ That should narrow it down to either being firewalled off or a config issue.

Your suggestion, relaxing dtmf in the config file.