开云体育

AllStarLink.org......where else ? Where it says in big green letters "Download for PC/Raspberry PI"

where is the IMG file to download?

I was looking for the bash command to get the setup for audio tuning, I found it in a PDF I had lost. (Part of the reason for asking) But I found it.. Thanks.

What photo are you referring to?

I used your settings and updated ASL3 and all is working! Thanks so much. Joe AF1E

What is the command to the second photo?

Michael, That was what I did on both of my PiHAT U and V. COS LED lit up when I keyed up the node. [events] ;;;;; Events Management ;;;;; ;status,2 = c|f|RPT_NUMLINKS ? ? ? ? ? ? ? ; Say time

I changed mine to linkunkeyct = ct3 Now I have a low pitch tone that no longer rips my ears. You get the original tone if you kerchunk and you're not connected.

Glad to hear that your node is working now. Now, my node is broken, and it’s not detecting any transmit audio from my Yaesu FT-5D. I think I’ll have to start again with a new image and configure

There are? a few ways, depending on how granular you want to make it. On my simplex nodes, I like to disable the courtesy tone of link received transmissions, but still have the one that plays for

SHARI PiXX working with "usb" instead of "usbinvert" for COSFROM is very strange.? Are you referring to CTCSSFROM instead of COSFROM.? Have you looked at simpleusb.conf to see if it set to "usb"

Thanks for all the help. I found the culprit! I changed the USBInvert option to plane USB and now it's working -- even the DTMF tones. 73 (Kind regards), Hendrik (ZS6HBS) Please visit my QRZ page

Hi, how can I disable the beep after every transmission from the Allstar node (ShariPi)? "Roger beep" is that how it's called? Cheers, Sander - VK6PI

I have a Shari PiHat-4U, and it is working with ASL3. Here are my configuration parameters: asl-menu: [image: image.png] 8. Interface Tune CLI: [image: image.png] sa818-menu: [image: image.png]

There are new updates for ASL3 available.? Please apply them. Here are the settings for the SA818 and simpleusb that I am using for ASL3.? Please try them.

There are new updates for ASL3 available.? Be sure to apply them.

You need to enable pre-emphasis/deemphasis.? You can do this in the SA818 or in simple USB.? You also need the PLfilter(simpleusb) or thehigh pass filter (SA818) enabled to filter out the CTCSS

Thanks for all of the help so far.? Here are my settings.? Let me know if you need more. Joe Speed is default

Good afternoon, On Monday I received my Shari USB radio that I use on a Pi4B. It works well in Hamvoip, but not in ASL V3. I got all kinds of errors while programming it via the sa818-menu, untill I

Please post screen clips of your simpleUSB and SA818 settings?