开云体育

There are new updates for ASL3 available.? Be sure to apply them.

You need to enable pre-emphasis/deemphasis.? You can do this in the SA818 or in simple USB.? You also need the PLfilter(simpleusb) or thehigh pass filter (SA818) enabled to filter out the CTCSS

Thanks for all of the help so far.? Here are my settings.? Let me know if you need more. Joe Speed is default

Good afternoon, On Monday I received my Shari USB radio that I use on a Pi4B. It works well in Hamvoip, but not in ASL V3. I got all kinds of errors while programming it via the sa818-menu, untill I

Please post screen clips of your simpleUSB and SA818 settings?

Here is a connect command to node 534630 that fails. Note the second "3" has a problem and the error is repeatable.? ?They sound fine on the radio (ID-50A) and DTMF speed is set to 300 ms in the

Are you starting each command with an asterisk "*"?? (i.e. *70 for status or *355553 for the level check parrot node)

Well looks like asterisk detecting your dtmf. What is the output on asterisk cli when you send connect dtmf from your radio?

There's a ASL3 bug that prevents you from connecting to 4/5 digit EchoLink nodes. ?The fix should be out real soon. ?If you want to test your setup without the fix then try connecting to 6-digit

I've tried to get echolink working on ASL3 and have been following this thread. I was wondering how I can check that my configuration is set up for echolink, e.g., that the correct module is actually

Hm, minutes after sending my previous question, I ran into some rather important information, and my problem now comes down to this known problem:

Yes,? I have run the rx volume test.? Here is me testing the codes.? I can hear the codes with no problem on a second radio but I cannot link, get the time, etc. by entering the codes in the

Did you set it up and test rx volume through simpleusb?

My node is a setup up with the new ASL3 and Supermonwith my Shari.? All is working well except I cannot input DTMF codes on the radio to establish links or get status.? All of this works fine in

The firewall problem has been resolved in the latest asl3-appliance package update a couple of days ago. Just install the package maintainers version of firewall.xml, and the zone should exist from

Also saw that same error. Somewhere along the way, things started to work; though I'm not quite sure what single thing did it. For what it's worth: A couple of notes of what I tried (in addition to

Interestingly, that was already enabled on my node. Maybe I did that and forgot to mention it? Not sure.

I'd love to hear/use an active system consisting of all SLIN16-connected nodes. Please post when this is a thing.

In order for me to use slin16, I had to update modules.conf with the following entry. I saw this error message on startup " unable to find a codec translation path: (slin16) -> (slin)" Danny/KB4MDD

This is the #1 reason we are overhauling two of our hubs from v2 and installing v3. Carl/K6CRS