开云体育

Not to sound ugly but have you read the instructions? Pretty straight forward and very detailed. -Brad

Mick, look in the file area here for a setup guide. Also all the required drivers are built in to the hamvoip version of ASL. I would also go to their site for a allstar how to guide. Darrell Black

The construction and setup information is in the "Files" folder of this group.? Go to Home page of the group and you will see the Files selection on the left side two up from the bottom.

Hi Steve and group, I just received my SHARI board (PI3U) and plugged it into my PI4 and ran through the simple USB setup and in less than 5 minutes (after programming my radio) it is up and running.

I have no such parameter. However, I do have these: L) Change CTCSSFROM Mode (currently "no") M) Change RXONDELAY value (currently "0") N) Change RXAUDIODELAY value (currently "5")

In Hamvoip SimpleUSB, what's TXAudioDelay set to? Or, are you talking about something else? My Kenwood doesn't go chk at the end of transmissions when I have CTCSS on both transmit and receive.

I really like these supplies have very little switching noise not even to effect any of the HF frequencies. They are of adequate amps to supply the Shari/Raspbery pi well

I agree. I purchased the VIlros Pi3B kit and it came with this power supply. I have never had an issue with Hum/Buzz and I like having the inline on/off switch. Loma KI5ISJ Sent: Friday, June 12, 2020

True enough,and so it is. I found something in the MD-380 CPS that might have been the culprit--the "Admit criteria" was set to "Always," so I changed it to "Correct CTCSS/DCS" but it made no

In the programming world 1 is on and 0 is off. Hope this helps. -Brad wrote:

I'm going to state the obvious, and it may sound snarky, but it's not meant to be. If the Shari is set to send a DCS tone and the radios respond, then I turn the Shari DCS off and the radios don't

I have the reverse burst turned on and I use a MD-380, a Baoefeng UV-5B and a Baoefeng BF-F8+. I don’t get a squelch tail on any of them. You might to run the shari-pixx-prog again and make sure the

I'm one of these people--I'm sure you know at least ten--who don't like squelch crashes and who think reverse-burst on CTCSS or DCS is the way to eliminate them. Therefore, imagine my surprise when,

Which cores did you get? I'm easily confusable by too many choices, and so far I've read about at least three. Not just diameter choices--actual electrical characteristic differences.

I got the VAB supply-charger someone mentioned somewhere recently, and while it's good, it's still not as good as a battery. Also, to anyone who might be considering the VAB device, or anything for

never mind. someone answered this already. Sorry for all the posts.

I agree with Patrick about the small ferrite not working.? In the investigation I did, I tried a supply with a small ferrite near the connector end of the power cable.? It was ineffective for

I would suggest a good quality wall wart? that is a 3 amp one & yes I do use? a ferite bead on all of them really not critical but I put mine a bit closer like 6" from the input. Dave on the hamvoip

Thanks for this.

Awesome! Thanks. :)