If the OSL calibration procedure is performed in the AA-650 Zoom,
then when the analyzer is connected to AntScope2, the program will
ignore the calibration. The program takes raw data from the
analyzer.
Regards, Alex
29.07.2021 14:48, michaelsurplice via
groups.io §á§Ú§ê§Ö§ä:
Can I ask a
really stupid question on this topic, if you calibrate the
analyser prior to connecting, by whatever means, to a device with
antscope running does it not use the data when plotting the chart
or does it ignore i??
Kindest regards
Mike M0AZE?
On 29 Jul 2021, at 09:57, Stuart Uggen /
K7ALM <K7ALM@...> wrote:
?Thanks for the clarification, Roger!
Stu
K7ALM
?On Wed, Jul 28, 2021 at 01:20 PM, Stuart
Uggen / K7ALM wrote:
That doesn¡¯t match up with my Antscope 2. Go
to ¡°Settings¡± on lower left corner of 1st page. You
should see three tabs after clicking on the settings
button. The 3rd tab from the left is Cable¡±. I don¡¯t
use this software often enough to really know it, but,
this goes beyond ¡°No cable loss tool¡±.
GL
Stu
K7ALM
Stu,
The Cable tab that you see under Settings have nothing
to do with calculating Cable Loss.? They are used so
that AntScope2 can add or subtract a transmission cable
length from the calculations.?? This is typically used
when you are measuring at the shack end of a
transmission line and want to know what the readings
would be at the other end.?
Roger
?
--
Alex RigExpert