开云体育

Vince, If you wanted to use APRS and Winlink on a RaspPi perhaps you should re-order your TNC to the one that plugs into the RaspPi GPIO header.? I'm not sure about APRS or PAT, but the PiGate

Also, make sure you are shutting the pi down gracefully with the shutdown command.? A lot of people just power it off and that will corrupt an SD card in a hurry ?Get BlueMail for Android ?

Ray Wow! It's a small world aint it?! HIHI? 73

The version for the Raspberry pi gets its power from the Pi.? The stand alone version gets its power from the usb cable. Mat

In California there are voice repeaters on this frequency.? Many have been on 442.925 for 30+ years, so check before using for APRS. I wish there was a 440 frequency as well, so don't think I'm

Vince For APRS? Definitely 145.175. I can only guess that there is some use being made of the 70cm frequency "somewhere" in Oz but I'm rural, around 350km from the nearest city

Ray What Freq's are more popular in Oz?? 73 vince

Possible oops, my previous might be interpreted as the 70cm frequency is "it". To clarify, for just in case, Oz does also have 145.175MHz as the 2m national APRS frequency. Ray

Mat Right. I tried contacting you offline... Thanks. -- 73, de Vince KD7TWW In what year did the FCC mandate the 1500 Watt PEP limit for amateur radio station power output? - Motorola Corp was

Ray Hmm... Wow! Okay, then... I learn som-fing new all the time! Thanks 73 de kd7tww

David 32gb, okay Sandisk, okay I have had a SD card go corrupt twice in a Rapb pi. Lost all my settings and hours later finally got the pi back online! Thanks for the url's? 73

Mark Nice explanation here. I understand just need to digest it. So power for the TNC comes though Micro usb on the Teensy? Can the ground be the same potential as my radios ground? Or should I

Probably directed at me. :) Mat

Mark My main focus would be Winlink2000 and APRS. IF that helps? TY 73

Mark Bought it. Boise Idaho . 3.6 chip stand alone. I'm sure I'll be intouch for support. HIHI.? TY

Mat I went with "Stand Alone 3.6. I hope I made the right decision. i'll use it with? a laptop. I'll be in-touch with the group pretty much all the time. I am fresh out of the box type of guy. But

Chris Could 9600 baud be used on a 70 cm Freq? I don't have my book handy to look. thanks -- 73, de Vince KD7TWW In what year did the FCC mandate th

David Okay. Thanks loads? 73

Check 442.925 MHz Eric

You are right. Spec says 25.