开云体育

Bruce , I just picked up a 400 kit with everything and a wired mouse. I am going to do a wireless mouse. I have a MFJ1234 so I am not looking for using this to replace what I already have. My question

After playing around a bit more, a hypothesis: A change from no password needed to password required at login may be the culprit (or not). In looking for ways to autostart lxpanel because the HamPi

Not specific to the FT-891. On all my radios, I cut the power cable about six inches from the connector to the radio and put on PowerPoles. Using a variety of power sources (battery, power supply,

Hi Guys I am putting together a ft-891 along with a Raspberry Pi for POTA and was wondering about the power cable for the ft-891. I want to build a short cable, do you include fuses on the cable. Do

Did a check on the WM site after the heads up on the cards.? Within the pickup and delivery side, they are listing the SanDisk 32 GB ultra class 10 cards for $9.48 and the 64 GB versions for $13.98.

WalMart has SanDisk 32G cards for under 20 bucks

Am I doing something wrong or is version 1.2 quite a bit larger when extracted than version 1.1? When I tried to burn an 16G SD Card with balanaEtcher, I got an error (the image is too large). So, I

I should add that when I discovered this and couldn't immediately track down the cause, I reflashed the OS, and again, after the install finished and the system auto-rebooted, all was well - until I

Are there any ideas?

Well done, Dave. It installed quickly on my RPI4 (8Gb, dual monitors). And now for the "however." ;-) After getting my monitors to display the panel and desktop items on the desired monitor, I

Yeah sometimes things just fail for no reason. It's not hard to have a backup on hand for $35. Same for the SD card. Cheap insurance.? Mark?KD0QYN? On Tue, Dec 8, 2020 at 1:41 PM, Doug

Hi Dave, Please send out the file, "UPGRADING_FROM_PRIOR_VERSION.TXT", that was not attached to your announcement. (Or put it on the wiki...) (Only the torrent link was atached) Tnx & 73, Dave

Thanks for the suggestions.? Yesterday, I finally got in via SSH and edited /boot/config.txt as suggested.? No joy.? I re-verified no HDMI output by connecting a working monitor/cable from this

The jumpers should be on pins 2 & 3 if it's used as a Pi Hat. Page 15.

How to send you a eQsl card to remove the notice? I tried via QRZ. Stephane VA2XMP 73 Le mar. 8 déc. 2020 01 h 00, Dave Slotter, W3DJS <slotter@...> a écrit :

Is the torrent active? I see peers but no seeds.

Hello How can i update Cqrlog to the 1.2 v since there is a bug fix that fixed the communication between wsjt-x and cqrlog. With v 2.3.0 there is a problem transferring? qso. I have installed ver

Fellow Hams, I am pleased to announce that HamPi 1.2 <https://github.com/dslotter/HamPi> is now available for public download! Please use the attached BitTorrent file to make it easier for everyone

Yeah, if the HDMI monitor is not powered on when you power up the Raspi Pi, it won't display anything, unless you force it has noted below by someone else. MarkKD0QYN

I am not sure how to do that. Evening else is working and I can see ports when are active. ?So how can I tell if its corrupted. Tim KM4ESU