开云体育

Mat, A socket would be nice, but I think you'll gonna need to decide on the Teensy 3.2 or 3.6.? One socket won't fit both these boards.? The 3.6 would be better since it will support ARDOP once it

Prefer it socketed. Steve Stroh (personal / general): stevestroh@...

I prefer in a socket. -- Bill AA6BD

My name is Mat and I am the one who is running the WVCARC Etsy shop.? For those who have purchased a TNC-Pi9k6 from Costal Chipworks or from us, do you you have a preference as to if the Teensy is in

Please don't hijack threads as this makes searching old threads for solutions a mess. Re-post your question to a new thread and I'll give you a hand. Btw.. I don't think your issue has anything to

With following result - Alf OH6IH

Please show us what you entered and the response. Chuck

Hello Alf, Maybe something like 64-bit instead of 32-bit for the 32-bit Pi3 ? Have you tried this link for info ? <https://physics.princeton.edu/pulsar/k1jt/wsjtx.html > Regards, Ian..

Since this is a very old thread, I hope no one minds me kinda hijacking it a little! %) I have an RPi3B running direwolf, callsign N7UV-3 (was N7UV-2 until about 30 min ago, just changed to make sure

Hi, Alf: ?My first WSJT-X on a RaspberryPi was a model 4-1G. It used a small amount of /swap. I upgraded to a model 4-2G and it works well. No /swap used. Perhaps your model 3 does not have enough

Welcome to the group Michael. Best 73, Terry, KB8AMZ

Hi, my update failed - have a Raspberry Pi 3 ... 73 de Alf, OH6IH

Hi, I have tried install WSJT-X 2.1.2 according to two different videos on youtube, but without success. Now I installing 2.1.0, but is it possible install 2.1.2 now also? 73 de Alf, OH6IH

Hello Isaiah, Where did you put this diode? Your solution doesn't make any sense to me as no packet cabling solution I've seen before as needed a diode. I fear you have something

I had tried to import my adif log from N3FJP into CQRLOG but ran into difficulties getting a clean import. ?Finally ended up with 90% importing. ?When I used FLdigi and FLlog, it came in clean. I

Just joined. ?Name is Michael and call sign is KK6ZGB

Yup, had to go negative. Thank you so much again for all your help! john.h.tetreault@...> wrote:

Ah... So the typical Baofeng Kenwood style connector PTT needs to be pulled to ground to activate... So, unless you did something weird in your hacking of it, you should specify inverse logic in your

I was able to get it to work with a diode. Thank you again for your help! I reverse engineered a baofeng to get it to work. john.h.tetreault@...> wrote:

I don't think it's that.... Do you know if your radio's PTT circuit is active high or active low? I.e does it need 3.3v to activate PTT or does it need to be pulled to ground to activate PTT? If it