The dhcpcd.conf was created using eth0 and it would also setup wifi with wlan0.? When I right clicked on the network icon in the upper right corner. and then to Wireless & Wired Network Settings all that was given was eth0 and wlan0.? Here is what I see when I enter ip addr:
$ ip addr
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
? ? link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
? ? inet 127.0.0.1/8 scope host lo
?? ? ? valid_lft forever preferred_lft forever
? ? inet6 ::1/128 scope host?
?? ? ? valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
? ? link/ether d8:3a:dd:12:ab:a7 brd ff:ff:ff:ff:ff:ff
? ? inet 192.168.1.194/24 brd 192.168.1.255 scope global noprefixroute eth0
?? ? ? valid_lft forever preferred_lft forever
? ? inet6 fe80::c1e3:8a87:c79:9f5d/64 scope link?
?? ? ? valid_lft forever preferred_lft forever
3: wlan0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN group default qlen 1000
? ? link/ether d8:3a:dd:12:ab:a8 brd ff:ff:ff:ff:ff:ff
Don - kx9q
