Hi Everyone,
I have been trying to get PAT Menu setup with my HAM Pi image on RPi-4 which is hooked up to a Xiegu G90. I have watched these series by to get everything going. Here is the part 3 of it, which talks about Rig Control:
Unfortunately i not able to get rigcontrol to work properly with flrig. I have made sure i entered everything correctly especially in the .json config file? found here: ~/.wl2k/config.json
I also double checked my settings with the url .
I also made sure i for the right model(According to Xiegu and many other websites, this model G90 works well when Icom IC-7100 is selected @ 19200 Baud). And this trick of using IC-7100 works no problem with wsjtx and other related software. This model comes out to '3070' when the output rigctl -l is printed to the terminal.? The following is the command i use to start the daemon.
rigctld -m 3070 -r /dev/ttyUSB0 -s 19200
The PTT doesn't work and i dont see any interaction by Pat to flrig when i hit Conect.
So the question i have is, should i try a different model number with rigcontrol?? Has anyone had luck trying to get? rigcontrol with flrig and using pat? I checked hamlibs supported radios , there is still no official support for the Xiegu G90.
The latest version of flrig does seem to have the Xiegu G90 added in its list of Transceivers, but i wonder if its worth the update if in the end rigctl is not going to support it.? Attached(below) are the relevant screenshots.
