What power supply are you using?? Just the bare Pi4 the Raspberry Pi foundation recommends a 3.5A supply... With the hat and any other accessories, I'd suggest at least a 5.1v 4.0A supply
On Thu, Jul 2, 2020 at 7:34 AM Bernard f6bvp <
f6bvp@...> wrote:
Downloaded Hampi 1.0 via torrent stream on Ubuntu. Two attempt with dad failed on freshly bought 32 Gb SD cards. After partitioning with flatted and true formatting under Win10 I succeeded burning image with Balena Etcher !
After booting partition was not expanded to whole SD. I did it with raspi-config.
Running RaspBerry Pi 4.
Frim time to time system is freezing.
i must shut down 5V to reboot.
DRAW hat is not recognized despite performing /boot/config.txt settings. With previous image from NorthWeStdigital DRAWS is functioning well.
Bernard, F6BVP / ?AI7BG
