-----Original Message-----
From: Spence M0STO via Groups.Io <unavailable.equal@...>
To: RacalRadio <[email protected]>
Sent: Wed, 18 Dec 2019 16:27
Subject: Re: [RacalRadio] Racal Cougar Battery Pinouts
Yes ordered but doubt they have been dispatched. Not cheap but not exactly expensive. ?33.69 + VAT each. Do you want one as I can just get Sam to order me some
More?
On 18 Dec 2019, at 16:04, Stuart Mckinnon via Groups.Io <stuartjmckinnon@...> wrote:
Spencer
have you ordered yet, I could do with a couple if you can help, no doubt will CU in Feb if not before?
Stuart
TBI
-----Original Message-----
From: Spence M0STO via Groups.Io <unavailable.equal@...>
To: RacalRadio <[email protected]>
Sent: Wed, 18 Dec 2019 13:10
Subject: Re: [RacalRadio] Racal Cougar Battery Pinouts
Not sure about those. Always run mine from a linear PSU
De Spence M0STO
On 18 Dec 2019, at 13:01, Robin Maddison <robin@...> wrote:
?Dear fellow radio amateurs, I am the owner of about 6 x PRM4515L¡¯s which have been refurbed and repaired. I¡¯m also fortunate enough to own a handbag programmer, 3 battery conditioner chargers, ECUs and SMTs alike however the one thing I¡¯m surprisingly short of is batteries. I have a few primary cells that are unissued and a handful of secondary Nicads. Problem is that of the 5 or so secondary cells that I¡¯ve tried to disassemble to re¡¯cell have always just crumbled. Most of the time they are also potted and a nightmare to break out. I know that the internals have a diode and a thermistor however the wiring is super complicated for something so very simple. Does anyone have a correct schematic and values of the diode and thermistor as good clean secondary cells are very, very hard to come by.