开云体育

Joe, First you have to select a media type on the printer under the paper setting options. The printer comes with There are basic paper media files, with the thickness, platen gap and .icc profile

You set the paper type on the printer itself. That is just the size of the paper.

Ah got you. Please have a look at the attached screenshot. I created a plate profile using the media installer. It is listed as a custom paper in the list. So I guess this is the way to go and not

You can run a plate directly if it is big enough (11x14) and no you have to switch inks by choosing the paper type in the epson media installer.

You need to install the epson media installer in order to change this. Epson thinks we are too dumb to change from photo black to matte black and so now you can only do it by choosing the paper type

Thank you so much Greg. Will see what I can manufacture. Looks like it is not possible to send in the plate on its own? Apologies if this sounds basic but I am totally new to using QTR and DTP

Thank you for this information Dave. I appreciate IT. I have installed the QTR software but still getting around it as I’m totally new to this. Not sure how to select a media type. It is not

Yes I use a carrier sheet. a 2ply board and a thick sheet of paper underneath to hold plate. Also make sure you go into the printer and turn off "Detect Paper Meandering” and also every time before

Joe, I had problems getting the P900 to recognize the "sled" that I was using for the plates. I took clay harmon's workshop on dpt and he showed us the use of a sled - using two pieces of 2X matte

OK sorted Greg. Thanks again! One last question if you don't mind. Is there a need for a carrier sheet for the plate? I came across this somewhere. thanks Joe Joseph P Smith MFA Digital Arts

Thanks again Greg. Installing as we speak. Joe Joseph P Smith MFA Digital Arts (Melit) MSWPP; FMPA; FBIPP; Hon. FMPS; ARPS; AFIAP Instagram: @smithfoto59 Facebook:

Platen Gap is 4.5 and drying time is .5 You want the platen gap as wide as possible to avoid head strikes.

Thanks Greg! Much appreciated. Can you please tell me the value of the platen gap and the drying time per pass as they are not that clear on the screen shot. Thanks again. Will download the media

Hi Joe, You need to install the epson media installer. Copy the Fine Art Matte and change it to these settings. Greg ?

Hi all Just joined the group. I am a photographer and a printmaker and recently started working on photogravure. Had my plates made for me up till now but I have now an Epson P900. I have downloaded

Hello Dave Thank you for this useful info. I have just started doing some DTP photogravures on an Epson P900. Any idea what the media setting (paper) should be on the QTR? thanks and best

Thanks for the reply. Please note that I sent a message to support@... on June 26 and to [email protected] July 7 . Having no answer, I put this issue to the QTR group. -- JYBusson

Two different products, but discussed in the same group. I have the impression, that this creates confusion among some. Richard, wouldn't it be an idea to create a dedicated group for your

Also, those crash reports are never all that helpful, and better to email me directly at support@... with the measurements and quad files rather than using the QTR group for this kind

This has been an issue from day one, and as best as I can tell, it comes down to the app trying to update the graphs before it gets all the data. I think I finally fixed it in a new total rewrite of