开云体育

Hello to the Group, Would like to add that a Pi-Star imgae is only built for use with a few SBCs when QnetGateway can run on more than just a few.? The power of module build is better suited for

Thanks I think I will leave it alone then... I'm not yet expert enough to mess with stuff that can mess me up too much. "Nothing adds excitement like something that is none of your business" Note I

The 50 second timeout is specified in the QnetLink.h file, near the top of the file ("#define TIMEOUT 50"). You can experiment if you like: uninstall, edit the file, recompile and install. If you want

That makes sense. Would it be possible to increase it? say to 90 seconds. I know I like this. Terry went on to most of the "violators" are NOT running Raspberry Pi based programs like Qnetgateway

Just for clarification, QnetGateway does not hammer its relinking attempts. Its very conservative. Their servers are likely getting hit with more malicious traffic every second than the 50 second

This is from Terry (N8LN)...? and a related question is there any way to change the re-connect attempt time delay? I did get blocked for a bit on REF030 due to "hammering" with just the one

Thanks to Tom for putting this together! I have been using this build for a while now.? I have it on a couple of hotspots, and it is running on my repeater.

Incredible Tom.? I think I will wait a bit.CartySent from my T-Mobile 4G LTE Device

For some time QnetGateway has supported MMDVMHost as a modem type. In the MMDVM.README file, I use to say that you could add other modes and left it up to you how to do that. Thanks to a lot of help

had that happen once was starting to wonder "WTF" but when I saw all the "Not Installed" messages. I thought "Install system" had a friend who tried to install Qnetgaterway over Raspberry PI- did

Sorry you're having trouble Cameron, but the line "Module C - qndvap is not installed" means just that. Maybe you should post your qn.cfg file.

Maybe I'm dense, but I configured and installed following the instructions for DVAPs. ?DVAP works and responds, but won't link to anything. ?I am registered on DPlus, but I can't even link to REF

*I think I found my mistake (Forgot to* sudo make installdash)

Figured out why I could now SSH into Pi-star after changing wi-fi configuration Stupid user error in case anyone wonders (ssh 192l.. instead of ssh pi@192.....) But alas was a couple minutes too

Ended up going back to Pi-star.UK and making a new supplicant file. So now it's connected to the new router and I can access the dash. BUT alas I can no longer SSH into it Oh it responds but rejects

On an RPi, wifi is controlled by /etc/wpa_suplicant/wpa_suplicant.conf. Here is an example from one of my Pi Zero Ws: ---------------------------------->8??

Ok I googled how to do it on Raspberry pi but remain confused Anyone have a suggestion. I know one way to change but not to add.

Wanted to clean out the last heard log on the Dashboard.. Decided to try "Restart"? (GX) sure enough. worked like a charm. Remained connected to the other than default reflector and cleared out the

First I had an issue with my ID-51 today. Dang thing just won't work after you do a US and GP and forget the IS step.. (Yup that's what it was) had a couple folks with ID-4100's they are trying

I tried it. IT worked, Did not like it, Changed back I like the fact it updates without messing up the UR field But I did not like the layout .. Will try again later when I have more time and can