|
Colby Ross W1BSB
¿ªÔÆÌåÓýI¡¯m a bit confused myself. Is this on a Pi? Have you changed the repeater¡¯s IP to an address on the same block your router and system are configured for?
? The IPs are configured in the qn.cfg file, you have to tell it what IP your repeater is on and what IP the gateway should be listening on. ? Show me the output of your /usr/local/etc/qn.cfg file, the output of journalctl -u qngateway, and tell me what IP your repeater is currently assigned, as well as your router, and the system you are running QnetGateway on. (The local IP addresses, i.e. 10.x.x.x, 192.168.x.x, 172.x.x.x, etc) ? Colby ? ? From: [email protected] <[email protected]> On Behalf Of Nomis Bayan Jr.
Sent: Thursday, September 6, 2018 09:26 To: [email protected] Subject: Re: [QnetGateway] Gateway - Raspberry Pi 3 -need help ? Hi Colby, Thank you very much. I did what you provided and did not see any error but it would not link to where I configured to XRF072 A (Set up BXRF072A). I am a little bit confuse in setting up the IP addresses and need assistance. I am using and assigned a fixed IP address to the Gateway and assigned it on my modem/router, the same set up I did on the XLX server. I appreciate if you could assist me in setting up our Gateway link to icom repeater. Thank you. Questions: 1. QnetGateway/qn.icom.cfg: Do I need to change any IP addresses on the qnet Gateway Configuration? 2. Icom ID-RP2C controller: following the ID-RP2C manual, setting is currently Gateway IP address: 172.16.0.20 and port is 2000; Communication Settings IP address: 172.16.0.1, Port 20319, Subnet 255.255.255.0, Def Gateway 0.0.0.0. Do I need to change any setting on the controller? 3. Where do I enter the static IP address (purchased five fixed IP address from AT&T)? ? On 9/5/2018 9:20 PM, Colby Ross W1BSB wrote:
? |
