Hi Tom,
Thank you very much for your feedback. The day after I send my post,
I upgraded the firmware of my ID-4100 to the one which was also
mentioned in your reply. And you are right, now it works without any
glitches or EOT errors.
Usually, I run the QnetGateway 24/7 and only switch of my radio. It
still happens, that my radio doesn't get a reply from the gateway,
even if I wait for 5 minutes or even longer. In this cases, I need
to restart the gateway.
- Is your software polling the configured radio frequently and
will reconnect it automatically after I power it on?
- And is there any kind of watchdog which can restart the
gateway in case of malfunction?
My target here is to run the OrangePi Zero headless without
touching it any more. Next time I see this behaviour I will also
check the status of the gateway and all dependent processes and
try to provide more information.
I also want to know, if there is an auto update of the configured
gatewaylist? Or do I have to configure a cron-job by myself?
Finally but also off-topic is about the DVRPTR v1 support: This
does not include the additional AMBE-board, right (same as G4KLX
DStarRepeater)?
vy 73 from Singapore de Stephan 9V1LH/DG1BGS
Am 09/02/2020 um 22:37 schrieb Tom
Early:
toggle quoted message
Show quoted text
I don't know anything about using a MAX232 in place of the Icom
USB to serial converter cable. I'm afraid you are on your own with
that. All I can tell you is the Icom cable requires a baud rate of
38400.
Make sure your radios have the most up to date firmware (currently
2020/01/31).
The qnitap log would be useful (turn on qso logging).
