Good job Tom,
What power supply did you pick to use for the 4100 and do you
think you would set it up to run the it in access mode?
Will
On 1/4/2020 10:07 AM, Tom Early wrote:
toggle quoted message
Show quoted text
I finally got my 4100 installed in my radio room. I updated the
4100 firmware to the 12/13/2019 version. I'm running on a
raspberry pi 3 using fully upgraded buster (10.2) and it seems
very solid in Terminal Mode. Had it linked to XRF735A last night
for the entire Trains Net, including the pre-check-in. This
morning, I've been connected to REF030C for three hours now with
no problems.
