开云体育

I Insert this reply here because if you are having the problem I stated above, the rest of this thread is unnecessary, though it might be of interest for other reasons. ?The bottom line is the latest

I shoots flats at low gain because my flats panel is quite bright and I want to use a shutter speed of at least 1 second. This is to avoid any unevenness of lighting across the frame due to the

David, I've been following this thread and haven't had much to offer since I'm using NINA. I have been under the impression High Gain is for 1x1 bin flats lights and bias and Low Gain is for 2x2

I don't think there is an issue with the QSI Ascom software. I'm using NINA and, as already mentioned, clicking on the Settings button in NINA prior to clicking on the Connect button, brings up the

Thanks, 7.6.2971.17 I think the QSI universal driver I have does not support dual gain cameras and hence it grays out the gain setting in setup. It is frustrating that the minimum exposure in the

Hi Bruce. Which version QSI driver package have you installed? The latest version available on the QSI support site or an older one from the CD that came with the camera, or something

I'm coming into this late, so I may be off target, but in Nebulosity for the 683 your choices are 0 (low gain) and 1 (high gain). I've never used my 683 with ASCOM or anything else. It works great

Not sure it matters, but my camera is a 632 - different chip. But assuming that the “dedicated QSI Maxim Plugin is the "QSI Universal” option under the camera selection window, method 1 does not

Hi Bruce. To change the QSI 683 camera gain in MaxIm depends on the driver method that you are using to connect to the camera, plus there are differences in the appearance of the driver setup menus

My QSI 532 died, and I replaced it with a used 632. ?The latter has a variable gain that defaults to "high". ?I need to change this to Auto. ?The manual says this has to be changed in the driver

Hello Ray, My apologies for responding to Stan instead of Ray. I was moving too fast. Thank you again, Phillip

Stan, Thank you for the information. I will contact Atik and see if they service the 683. Thank you again, Phillip

Phillip, Don't know if this will help but I have both a 583 and a 683. They are exactly the same except that the 683 has a much higher speed read. That implies the USB interface in the camera is

Hello, It appears the shutter capstan drive on my QSI 532ws has come loose and it no longer turns the shutter. I contacted Atik service and learned that they stopped servicing 500 series QSI cameras

Hello again, I can't tell you so much technicality. I can only refer you as a mere amateur to the website of my astrophotographs indicated in the sales link. This camera is a gem of a sensor.

An extended area, that does not get light but still usable for better calibration https://www.astropy.org/ccd-reduction-and-photometry-guide/v/dev/notebooks/01-08-Overscan.html Nicola Il giorno ven

Hello, I don't understand, overexploration area?? El jue, 5 oct 2023, 20:37, NIcola Montecchiari <omega.centauri@...> escribió:

Dear All, Do you know if the QSI683 has an overscan area and how to get access to it? Thanks -- Nicola Sky Monsters - http://www.skymonsters.net Skype: betelgeuse368

Thanks, Geof, I appreciate your taking the time to comment on it. Cheers, Bruce Sent: Monday, September 25, 2023 9:09 AM To: [email protected] Subject: Re: [QSI-CCD] Sh2-135 image

Bruce, Sorry for my tardy reply, I think I originally saw it when travelling, then lost sight of it under lots of other emails in my inbox, so just came across it again. It’s a very nice