¿ªÔÆÌåÓýYes and yes. There is a backup battery that may need replacing and the rig can be reset by holding down the MEM button while turning on power. The battery can be replaced as follows: 1. Remove the top cover and be careful not to stress the speaker leads. 2. The Li battery is visible from the top near the rear of the PCB -- it is coin type about the size of a nickle. 3. Use a small screwdriver to lift out the old battery and replace it with the same type. 4. Replace the cover and reset the rig by holding down the MEM button when turning on power. if you want a copy of the manual, you can obtain one . 72/73,Larry W1HUE On 12/1/2019 6:50 PM, Irena &
Richard Jenkins wrote:
My QRP+ has been silent for several years. I want to get it going again ... is there a reset to factory procedure?? I did turn it on a while ago, but it did not behave as I remembered. Is there a backup battery internally which may need replacing?? Richard VK1RJ |
