开云体育

Very good. Hope it goes well D

The origional buttons were not used . I had 2 extended push buttons in stock as wel as some cheap plastic potentiometers. The shafts were cut of and appeared to be hollow. A 1/8 ( 3mm) drill was used

How did you pull the push buttons out? David G4YVM wrote:

Hi Ryan FYI they aren't zener diodes. Just ordinary 1N4148. No harm in not fitting all the parts! That should all be fine. Be careful with the jumpers. The recommended construction has LPF #1 always

Hello All, I am building the arduino shield kit for use as a WSPR transmitter, and I have a question about timekeeping. Now clearly, the GPS kit is great and preferred for many reasons. In addition to

I only want to use 3 out of the 5 bands on the board. In fact I'll probably only use two of them- the one on the U3s and two on the LPF switch. Do I need to install all the parts? I raided two of the

Pinvise?https://www.amazon.com/Hobbico-Pin-Vise-Collet-Bits/dp/B000X4OIWY ( https://www.amazon.com/Hobbico-Pin-Vise-Collet-Bits/dp/B000X4OIWY ) Good Luck. 73 John PD7MAA

I used the PCB and a pin vice to mark the holes , see my blog http://pa-11019.blogspot.nl/ ( http://pa-11019.blogspot.nl/ ) The origional BNC connector is not used . Good luck

never mind fixed

I have searched and read through the board and cannot seem to find an answer. So..I just assembled my U3S and started it up. The diagnostic screen comes on and after I press the left button, I see the

Received mine via email earlier today also. Tim KB2MFS

Anybody made a template for this? ?Tnx 72 George/W2BPI

Wes Far from perfect, but I went plastic.? A black low profile multi CD case was spotted, a freebee from a conference advertiser. Easy to machine the display opening, and a generous top panel.?

Dear Hans and group, My QCX, GPS, and dummy load arrived today. Got some work to do next week My box Number 11611 Take care and have a great day. 73 Dave Hassall WA5DJJ Las Cruces, New Mexico Website:

Via email.

got mine via email earlier today… bests dave dabay kd3pc@...

How did you get it? Email? Sent from AOL Mobile Mail

Many US hams who sent their notification of intent to operate are now receiving approvals. Got mine a while ago and will be working on an antenna this weekend. U3S + 80-to-630m transverter U3S +

Wes WM7WM wrote... I have two QCX kits ordered (one on the way) and one case from QRP Labs. I won't know it will work until I have everything here, but the opening for the LCD display shouldn't be a

/ //Hello Wes and all wanting remote switches in a QCX// // //My detailed discussion with Hans assures me that _all_ the// //_QCX switches / key inputs_ are are debounced in firmware// //so that