开云体育

Hi, The box stores are convenient if not always useful. I also use the "beyond help" line. When I tell people in the *real* hardware stores about my plans for abuse they are intrigued, not ruffled.

Yes to invest in a hot air solder/desolder unit is one of my best investments -Now I can not do without it. It doesn't need to be the real expensive ones, but the one you can adjust the airflow and

Syd Here's my way https://sites.google.com/site/g4zfqradio/qrplabs_replace_si5351 I'm happy doing it that way, others here would not recommend it. We are all different. 73 Alan G4ZFQ

There are 2 SMD IC in the QCX kit. The synthesizer IC and the UProc IC. The latter one doesn't look too hard to work with, but the synthesizer IC is another case! That is so small that I can't even

I started doing these over ten years ago, and just bought a programmer from Adafruit. It of course was another AVR internally. Still use it for 328P bootloaders because it's convenient. So really if

QCX Classic and enclosure sold. QLG 1 still available

The Amazon ones that terminate into the little green screw terminals are not bad, they need to be physically substantial because of their bulk. But those are not ideal outside of testing. Though if

In the UK, the regulations require that every cable is protected by an appropriate fuse or breaker. The fuse (and 5A and 2A circuits) are about allowing smaller cables to run from the socket to the

Keep us posted... Jack, W8TEE

Switchcraft #760 or #762. There are other models that will work too but Switchcraft is where it’s at. :) Mike/w1mt wrote:

-------- Original message --------From: Fred Spinner <fred.spinner@...> Date: 2021-10-31 11:54 (GMT-05:00) To: [email protected] Subject: Re: [QRPLabs] removing SM ICs Hah.? Well every time I

Well, darn. You are ahead of me again! :) I actually did not even intend on working on mine as I didn't expect getting it this weekend. And probably won't touch it again until next Saturday. Your

Hah. Well every time I go to a hardware store or "Home Despot" type place and someone actually asks me if I need help (NOT often anymore!) after I tell them that "I am beyond help!", I usually say

Graham, Did you use 2 different prog rocks (one for tx and one for rx) ?

If you are looking for solderable individual plugs (not cable assemblies) I have recently bought Mouser Part number 490-PP3-002A. They seem ok to me at $1.42 each. If you look at the datasheets for

Hi Jim,? Jack, Jeff, Wayde , and John....?I very much appreciate all of your replies to my plea for help with programming the Atmega32P chip.? All of you spent a considerable amount of time to give

I’ve had good luck with Jex-Electronics in West Virginia. What I’ve ordered from them is well made. Among others, they sell to security system contractors whose systems typically use DC plugs for

The NOS QCX Classic, Bama Tec case, QCX, 20 Meters. Big dummy left the band out. Sorry, Gary W0CKI

Serious question: Can someone recommend good quality 5.5 x 2.1 mm DC plugs on Amazon/Mouser/Digikey/...... ?Yes there are millions listed on Amazon, and i ordered 2 different ?4.5 star rated plugs,

I have NOS kits. QLG 1, shipped CONUS, $30.00 QCX classic plus BamaTec enclosure. shipped Conus, $70.00. PayPal OK. Thanks, Gary W0CKI