开云体育

Here's one Jim. It's 15' so a little longer than you were looking for but not too bad...

Heck I was and other were running BPQ back in the 90's. A great AX25 packet switch along with the famous F6FBB BBS software. -- - 73 de Andy -

I appreciate all the help.? I have enough information to figure it out. Thanks to all!

The supplied coax is usually RG174. But any 50 Ohm stuff as an extension will do. -- - 73 de Andy -

I’d like to place my QLG2 antenna just outside my shack; already have a conduit in place for several antenna coax runs. Unfortunately, the supplied coax for the GPS is about three meters too short.

Bob, It looks as though to generate signals in the 144mhz range, the Si5351 will be using a fixed output divider of 6.? A simple Si5351 library that uses fixed point and does nothing fancy but does

I have built many QCX minis. I have never noticed this before, but then, I never looked before either. However, once I noticed the one at 7,052 after I had replaced the SI5351A, I started wondering.

Hello Rod What you say about birdies in direct conversion receivers is true in so far as, they does not suffer the multiple mixing products inherent in superhets and dependent on how much filtering

Nice! Is there a writeup on this anywhere? Thanks! 73, Willie N1JBJ

No. In another post I mentioned that another receiver does not hear these sigs. -mike/w1mt

Thanks, Michael. Yes I've let wsjt-x get old. My fault I've been using jtdx instead. I'll uninstall hamlib and download and install the new tar files and see how it goes. Thanks again. -- Phill EA5JHA

No issues updating my V.3 QDX. It's working great! -- 73, Dan - W2DLC

I have built a few of these clock kits recently for myself and friends. Power was the first consideration and most everyone wanted 12V compatibility and backup. I used the buck converter mentioned by

To determine the approximate length of wire needed I have always used: 2*(Height of Toroid + Width of Toroid), that gives you the distance around the toroid, multiply that by the number of turns and

Hi Was the QCX+ maybe listening to the TV? :) Regards

You need to update WSJT-X too....2.3.0 is way too old. https://sourceforge.net/projects/wsjt/ The new DLL should work for JTDX 2.2.159 I think. Mike W9MDB

Are you using the QDX entry in the riglist? There have been some updates.... New hamlib for installation directions #1 Shut down WSJTX #2 Download either the 32-bit or 64-bit DLL matching the

I guess I got lucky... plus I have a big box of wall wart, one was bound to work.? Have been powering my clockGPS for over 2 years with no problems.? However, now that I seem to be building more

To update or not to update, that is the question? Well I did and disaster! No transmit. Well actually the qdx ver3 does transmit via terminal but not JTDX V2.2.159 nor WSJT-X v 2.3.0 I've rolled back

Isn’t there a sheet in the band kit that lists the length of wire and number of turns for each? It’s been awhile since I’ve built my QCX+. Rick WA3TUU