开云体育

I have the same question Hans. Is it possible for invoice 72091 to be made for 9V?

Rick, was not an issue with the inductor/ pin 3, just brighter than I wanted. -- 73, Dan? NM3A

I'm just adding the #QMX hashtag, which I'd inadvertently left off. ?Thank you again in advance for any troubleshooting advice regarding the ~10ohm resistance detected across some of the A and B test

Just put in a 120 ohm (leaded) in place of the 33 ohm. Much softer and it's fine, but could have even gone to 150 or 180. Thanks for the info. BTW, I did not remove the 33 ohm, I just cut the one

Update: Definitely a toasted zener on the 3.3V PSU board. Hooked up 3.3 board to bench supply. High current draw, zener gets hot. Removed zener. Current draw now reasonable. Installed 3.3 board into

Please post pix, Sandy. 73 Jim K1IR

First fire up on QDX 20-10. Led flashes normally. L4 started smoking. Yikes! Now terminal shows only 80m, no other bands. Wsjt works into 50 ohms but usb sketchy Replaced L4. Removed Diodes D1

4 watts vs 3 watts is 1.25 db. IMO there are bigger fish to fry. I intend to run off a car battery inverter so I took some extra steps to ensure thermal performance at 13.8 vs. 12. I put thermal

My QDX was working fine until I was attempting to use it to drive a 100 watt HF amplifier. ?That amp failed, spectacularly, and now the QDX has these symptoms — 1. RX is good on all bands, with

Yup! Looking forward to the 'with' results! -- 73, Dan? NM3A

Without.? My plan is to get good data without, then add them and see what the difference is. This is Science isn't it?

Because 12V is greater than 9V? The 12V version has a different turns ratio on the output transformer.? So while the voltages on the output side are the same the voltages on the driver stage are

Chris, is this with or w/o Zeners? -- 73, Dan? NM3A

The short is somewhere on the main board, verified by pulling out the PSUs and testing each board individually. I wish the PSU was the problem since it's easier to just order another power module than

I think it's just a matter of being cautious. I use an Elecraft T1 to tune but use a tuning indicator (TI) that ensures no more that 2:1 swr is presented to the rig. I have forgotten to put the TI in

The tuner should be the last in the chain. QMX is transmitter and hooks up to TX side of the tuner, ANT hooks up to ANT side.

Why would 5W at exactly 9V, for the 9V version be ok, but 5W at exactly 13V, for the 12V version, be dangerous? FWIW, I’ve ran my QMX off a LiFePO4, transmitting with as high as 13.8V, but mostly in

The right encoder / button problems are likely a bad ground - upper left pin on the control board if I remember right.? ?Recheck that one, that six layer? ground takes a lot of heat.

Yes - I noticed that too late! My bad, the QMX should connect to XCVR. 72 Sandy KB3EOF

Great setup at low cost. One thing just wonders me: is the QMX connected to the ANT side of the tuner?