开云体育

Hans, Thanks. I’ll try and remember to order a case or two with my next order . 73s, Steve

Right handed here. Never noticed it to be an issue winding it any direction. If it is an issue, just wind the toroid 'upside down'. -- 73, Dan? NM3A

Hi Steve, Make sure that you're not in practice mode. When I tried testing my SWR a little way back, I got similer results and wondered if I broke something. I then realised that I had the rig in

Ok, I think I found the end of the saga. After a bunch of testing to verify I am confident in the board, I swapped in a 3V SMPS from another QMX I have. Good news, board powers up no issue! So now I'm

It shouldn't matter as long as you are consistent.

I would wind them clockwise for many kits, without any negative performance impact that I can discern. If the wires weren't conveniently lined up with holes, I'd simply rotate? the toroid on the

When using the SWR measurements in hardware tests I find the SWR reading is very unstable...varying from 1.5:1 to 2:1 in one particular case, this is true even when using a 50 ohm dummy load which

I have a crochet hook and rarely use it. I usually just thread the wire through as if I'm using a needle and thread?. I hold the toroid in my other hand. -- 73, Dan? NM3A

Thanks Paul, it's more for the fun of trying, I'm not using decoders....but yours is really impressive! 73, Peter

Agreed! - Nico [email protected]> wrote:

This is a really cool project. Just finished my QMX+ build a few days ago and I'd be interested in any upcoming group buy.

Given my experience with the one resistor, I'm thinking there is another solder joint somewhere in there that isnt happy. I got out the hot air gun and gave the whole board a remelt. Good news,

Do you have the sidetone volume set to "Absolute" or "Relative"?? If set to "Relative", I would try "Absolute". Otherwise, I think a CMC is your only option.? For QMX it can be very small, due to

Hi Peter, I've tried all the tricks on android but refuses to play ball, sorry. Paul,

Thanks Ludwig for all this informations. I will look into this in detail with experienced OMs and I will keep you informed of our investigation. 73 André F6APU

Hi Jerry, Steve QMX+ isn't a standard case it's custom made. I designed the enclosure to match the dimensions I needed for QCX+ then inherited that to QMX+. The extrusion isn't unique to QRP Labs,

This is one part of the assembly that is very natural for us left-handers.? :) Stan

I'm glad you found the resistor connection problem and fixed it.? Nice work.? I haven't heard of anyone having that specific problem before. Andy, did you read the startup section of the wiki I

Has anyone else noticed that the winding direction specified for winding the toroids is backwards for right-handers? It is also backwards for my Gorman Productor toroid winding machine, which was

Nice quick cheap source for a good quality case, very close to the QMX+ case in all respects. I measure the QMX+ case at 143.7mm front to back, the Amazon box claims to be 150mm. Could be an error on