开云体育

Hey Julian, Thanks for the reply! No, I can’t update the software myself I don’t think. I’ll look into it. Conard, WS4S

OK, back on line.? open the box and did not find anything.? Measured the BS170 in-circuit and found these values for them on my old M3 Analyzer.? It gave both of the values indicated, which I don't

Almost rolled off my chair laughing at the truth of that. Fortunately XYL is in the kitchen in a Zoom mtg, so I won't have to explain what I was laughing at. -- Julian, N4JO.

Hi, Conard, Backlight control didn't enter the picture until v1.06. but if your unit boots up showing "v1.05" - irrespective of what's printed on the chip label, you don't have that capability. Yes,

There is a voltage maintained for quite a while, over 3 volts on the electrolytic, 2.5 volts in places on the board. I'm thinking it needs a resistor or two to drain this away.

Hey gang, I just built a newly-arrived QCX-mini for 40. Aligned up perfectly on first powerup and all was well until I tried to turn the backlight on. Scrolling through the menu I can’t find

Andy, Is this what you are asking? The QDX fault condition here is that when the audio does not seem to be configured correctly. My last test first showed a bad audio trace, then the very high noise

Al The 24 bit 48KHz is reported to the OS, no alternative. 73 Alan G4ZFQ

Pretty much what I figured. Thanks! 73 /paul W3FIS

Hi all, I searched but couldn't find if this was already discussed, but it's another audio thing to keep in mind when using pulseaudio (the default on many Linux distro's). Today I was watching the

Potential buyer here, When the embedded STM USB sound card is detected by Windows does it set 'correct' bit depth/sampling rate? I've been reading over the QDX Instruction manual's circuit

Andy, The trials that I have done do not point to a USB audio issue.? There is something disturbing the QDX that causes it to go into a state where the opposite sideband is not being suppressed as

The next step would be to get some snapshots of what the OS thinks it has connected and probably to split it into 2 threads, 1 for Windows and 1 for Linux. Get the QDX working OK and then capture the

Unfortunately disabling USB auto suspend did not solve it for me. After a while the RX audio level was zero, JS8Call was in TX mode but the QDX not. And the audio and RF filter sweep looked as below.

Hi All, Everything was working fine, and then I switched firmware 1.01c.? When I loaded it up the QDX LED turned off.? I removed the power and then plug it in and the fast flashing occurred as usual

I have found that my issue was the different max audio out variation in my various windows machines (with out levels set at 100%).? On one laptop QDX works on 40M only and on an old windows tablet it

Hi Andy, This is interesting! I remember getting a 4-bay USB DAS to enumerate only after disabling auto suspend. So I just disabled auto suspend (added kernel option usbcore.autosuspend=-1) and

Guys, There seems to be lots of people with their guaranteed cures for USB issues all of which are ignoring the elephant in the room. USB is a hugely mature technology and if things are going wrong,

Oh yes, I use a third tool if I know who I'm looking for http://www.reversebeacon.net/srch.php (you can do this also with the map version, but this one has a simpler interface) just type the callsign

Hi Hans, we understand ... busy times for you. But of course we will be happy when you are back in the QCX parties ! Chris, best is to join the discord sked page (