开云体育

Love the radio looking forward to the build. My order number is?#50374 so still have a few days to go I imagine and shipping from Turkey to South Africa will also take some time so will be patient. I

Hello all Got my new kit up and working yesterday.? Still a whole lot to learn and a whole lot of manual to read. I am using a Raspberry pi 4 as the computer with the "Build a pi" software suite.?

I still keep a good old sealed Lead Acid AGM cell on the bench, both a 5 AH and a 12AH. They are cheap easy to charge and take a bunch of abuse. Not that I abuse them. I can leave them on the float

Hello, This is a very important step. Hans has advised *extreme care*. I suggest following Han's method to a "T'. Looking over my workmanship in the 50 watt amp. I see I didn't take this seriously

Yes they are, and absolutely he will. I might able to help, and will email you privately. -- Julian, N4JO.

QDX? #50063 just arrived in Nanaimo BC this morning. Shipped 7 days ago. 73 Hew VA7HU

Side note: are replacement processors available? ?Will Hans read this exchange? ?Thanks.

Ok will do. ?It was fully operational two weeks ago, and was purchased "Built", and not as a kit. ?I just sat down after pulling the cover and checking to see if the long 26-pin chip was seated

I am still waiting for my order #50000 shipping confirmation.? I have the PayPal email confirming payment at 1:02 CST (1802Z).? It may be that because I ordered more than one for our build club that

That single row of rectangles means the display hasn't been initialized, and is consistent with a non-functional processor. I suggest you first check all connections to the front panel, and make sure

Is this a Mini? If so, be VERY careful with wiring and using the extender, because it carries 12V for the display. If you accidentally short the 12v pin against an adjacent pin, it will almost

Well , Crap!!! I have not used my new little QCX+ 40M in two weeks. Just connected it to my regular trusty power supply and a proven antenna....and this is all I get. No display, no menu, no

Syd that short length of wire will make no difference. Make sure you have good connections and all the pins go to the correct other end points. It will work. I've extended these things 10" away with

Syd, the 20 meter filter almost always needs L3 to be one or two turns less than specified and expanded somewhat. You can verify this by expanding the turns on L3 fully and if the power is still

QDX in I/Q mode (new firmware) Receiving 24bit AM, LSB, USB, CW, FM I used HDSDR For CAT control OmniRig.

I think I was done with checkout about 2.5 minutes in. I was hoping one of the receipts (QRP Labs and PayPal) would say exactly when because it would be interesting in a useless sort of way, but they

I jury rigged 2 headers, male and female, together 3 inches apart so I could take the display off the main board and still see it while no longer attached to the main board and monkeying with the LP

I have two kits (20m & 40m) that need the band pass filters aligned. Hans's tutorial on aligning this section by compressing and decompressing the inductor turns to figure out how many turns to add or

LOL! Took me a while… server kept crashing on me. Probably 8 minutes in. Mike WM4B Sent: Wednesday, October 27, 2021 6:11 PM To: [email protected] Subject: Re: [QRPLabs] QDX Same here. 50001. That

Same here. 50001. That what I get for all my "constructive criticism" in the past I suppose! :). Still good news though. How many seconds after 1800z were you again? :) Fred W0FMS