开云体育

Allison, Not sure if this should be for you but do you know if there will be a writeup on the design of the PA circuit akin to the one Hans did for the QCX? From what I've read I feel like this PA

Hi Ken Yes! The suggestions are all very useful! A couple of the requests were a bit far out. But many were new ideas, and very much appreciated. I'm sure that many will make their way into the

All excited future kit builders, hey, when did we ever get to put our dreams and desires for a rig into the early days of design? with any of the 'bigger' manufacturers where we were listened to and

I prefer to use a folded piece of very fine grit sandpaper. Just pull the wire end through the folded sandpaper a few times and the varnish is gone. No knicks…just bare wire! Sent: Wednesday, August

I'd like it to be able to operate my toaster too, if possible.

from 50 years as an electrical engineer: The latest "improvement" is always the source of the newest problem. If you want an all band, all mode, transceiver with internal ATU and Battery, Elecraft

Tries double clicking left button and clicking right button. Did not cancel RIT -- Have a GREAT Day Tom KS5X@... --- This email has been checked for viruses by AVG. https://www.avg.com

In operating mode display reads VFO and Frequency top row,then -2,040 bottom row which I believe to be RIT off-set. How do I reset RIT? Have a GREAT Day Tom KS5X@... --- This email has been

Also, no matter how I remove the enamel coating, I always check the leads with my DVM for continuity, just to make sure. I prefer to gently scrape the coating off with a box cutter, taking care not to

Writing anything to this group demands a little thought, most people seem to be starting in the hobby so don’t have the experience or piles of materials that others have. A little enamel residue is

Hi Alison, *No worries.* Of absolutely no interest to anyone.... email was sent prior to a read through, wasn't supposed to have cryptic initials, more like things for me to check before launch. SW=

From: Rick Barnich <mailto:ka8bma@...?subject=Re:%20QSX%20radio%20feature%20requests> Date: Thu, 23 Aug 2018 09:53:21 PDT ... The problems and delays were always caused by changes and new

Which makes my request unnecessary and is what I had expected anyway, thus why I hadn't bothered to ask it till now. Its all good : -) From: Hans Summers

I wasn't willing to assume I could run the rig without the LCD connected, but if it is safe I can see that as an option. Thanks! I think it would have been better for me if I could have built it up in

Alan, No foul intended.? The KB1OIQ was based on arduino and I've pushed him to consider? as a possible mod to output cat controls as a front end box for cat enabled radios. His not doing this is a

All, I am a casual follower of this forum and was excited to see the QSX announcement. The ink was hardly dry and the requests for additional features started pouring in. If you recall, when the QCX

I always scrape enameled wire, and have never had a problem with breakage.? Use the *back* side of the Exacto blade or a razor knife to reduce chances of nicks.? That side is duller, but scrapes

Hi Dave Apologies if it is not clear. 1. Basic: 40m transceiver. It could be built for any HF band with appropriate BPF and LPF components. 2. 10-band filter board option. 3. Enclosure option. 2 & 3

I burn the enamel using a butane lighter, remove the residue with fine grit sand paper, and then tin the wire. It works quite well. 73, Art WB8ENE wrote:

I have been thinking the same thing, that it'd be nice to add a battery and perhaps an ATU. I suspect others might also have this thought too since these are offered by other radios with similar size