开云体育

Hi, I second Simon's opinion: FT-8 is a highly interactive mode with seconds to interact and was never intended as a beacon mode. Beside that the QSO runs in automatic mode. No chance to implement

rule one, remember to take your towel ;-) db

Hans, ?Have you looked at going to say an ESP32 device? They would certainly eliminate any constraints for a long time on memory, cpu, I/O, etc.? I don't know what price break you get on the Atmel

Error,I meant replace Opera with FT8. Jim

Dean, PI4 is being used with good results and just my opinion,should replace CW beacons altogether.Not many people are aware of this mode and how useful it is. Software is almost too simple to use -

That's why I asked about (and deleted) rig control... I've only seen FT8 used to make QSO's. And yes, it's not easy

Dean, This seems to be becoming a popular "QSO" mode. Is there really any interest in making it yet another beacon mode? The WSPR sub-band is the place for that. 73 Alan G4ZFQ

Can't remember what it said! ?I think I tore the article out of the paper for future reference if I can remember where I put it!!! Love Dad

No, no , please no. FT8 is a 'QSO' mode and letting loose FT8 beacons in the FT8 sub-band is, in my view, pointless and counter-productive and not at all in line with the ethos of the mode. I find it

Just program a short beacon message, like JT9, JT65, etc. So a FT8 beacon. I'm not sure how useful that is... 73 Hans G0UPL http://qrp-labs.com

Hi Dean I already coded FT8 in my U3, next version v3.13, last week. I have not yet had a chance to test it. v3.13 also contains JT4 and RTTY modes. 73 Hans G0UPL http://qrp-labs.com

I think there are two answers to this one, but i'll ask all the same! Any chance of FT8 mode being included in the U3 firmware. I know the room in the ATMEGA is tight!? (PI mode anybody still use

Alan, that should be written on the cover of a comforting book :o)

Hi Peter That fix for the WSPR encoding will be in the next firmware release. 1.00e. 73 Hans G0UPL http://qrp-labs.com

Colin, Rule 1) DO NOT PANIC! 73 Alan G4ZFQ

Mike I had to unscrew mine. I'd suggest ignoring Hans on this point and only use a few screws like I did when I reassembled. 73 Alan G4ZFQ.

Hi Hans, I had a look at the building instructions again and saw that I had stupidly forgotten to add the jumper for the PA,? I have been running the kit up to now with a separate power supply for

Hi Alan, I had a look at the building instructions again and saw that I had stupidly forgotten to add the jumper for the PA,? I have been running the kit up to now with a separate power supply for

Hi Hans, does the 1.00d also contain the fix for the WSPR encoding (as described in?/g/QRPLabs/message/18134 )? Or will this be included in a future release? best 73, Peter,

Hi Keith You can remove it on all. It was only intended to be an additional protection during shipment. 73 Hans G0UPL http://qrp-labs.com