开云体育

No, no , please no. FT8 is a 'QSO' mode and letting loose FT8 beacons in the FT8 sub-band is, in my view, pointless and counter-productive and not at all in line with the ethos of the mode. I find it

Just program a short beacon message, like JT9, JT65, etc. So a FT8 beacon. I'm not sure how useful that is... 73 Hans G0UPL http://qrp-labs.com

Hi Dean I already coded FT8 in my U3, next version v3.13, last week. I have not yet had a chance to test it. v3.13 also contains JT4 and RTTY modes. 73 Hans G0UPL http://qrp-labs.com

I think there are two answers to this one, but i'll ask all the same! Any chance of FT8 mode being included in the U3 firmware. I know the room in the ATMEGA is tight!? (PI mode anybody still use

Alan, that should be written on the cover of a comforting book :o)

Hi Peter That fix for the WSPR encoding will be in the next firmware release. 1.00e. 73 Hans G0UPL http://qrp-labs.com

Colin, Rule 1) DO NOT PANIC! 73 Alan G4ZFQ

Mike I had to unscrew mine. I'd suggest ignoring Hans on this point and only use a few screws like I did when I reassembled. 73 Alan G4ZFQ.

Hi Hans, I had a look at the building instructions again and saw that I had stupidly forgotten to add the jumper for the PA,? I have been running the kit up to now with a separate power supply for

Hi Alan, I had a look at the building instructions again and saw that I had stupidly forgotten to add the jumper for the PA,? I have been running the kit up to now with a separate power supply for

Hi Hans, does the 1.00d also contain the fix for the WSPR encoding (as described in?/g/QRPLabs/message/18134 )? Or will this be included in a future release? best 73, Peter,

Hi Keith You can remove it on all. It was only intended to be an additional protection during shipment. 73 Hans G0UPL http://qrp-labs.com

Hans G0UPL Thanks for the info. I removed the tape on the first one, but I'll leave it in place on the second one. -- 73 Keith VE7GDH

Cory KD9INL wrote... Thanks for your reply, but I wasn't referring to what I assume is double-sided tape on the patch antenna. The clear tape I'm asking about is is the RF Module YIC51612. PS - your

Hi Keith The reason for the tape is that it provides some additional protection during shipping - both the bulk shipment from the manufacturer to the warehouse, and from the warehouse to you. What

Bob ZL1RS wrote... Yes, that is the RF Module that I'm referring to.I have two GLG1 GPS receivers. Both had some clear tape over the YIC51612 RF Modules. I was just curious what reason was. See

Answering my own question. Set the bias per the manual. The high setting for PA voltage is a little over 7V. I could go higher but it's a weak signal beacon not VOA. The OCXO wasn't drifting because

I've had the U3s on the left in the photo below for quite a while (at one time it had the relay board installed). It was my first one and I bought the OCXO version. The first time that I put the

Mechanical rigidity, so the patch antenna isn't held to the board just by the center pin. [email protected]> wrote:

On 6/12/2017 1:50 PM, Keith VE7GDH wrote: Does anyone know if there’s any special reason why there is tape on the GPS module in the GLG1? TIA. ... on the GPS