开云体育

Hi again,? Well, I found the problem. Took out the synth board once more and connected to a 5v supply, 3.34v on pin 18, 9.4 mv on pins 17, 18 and 20 so synth board ok. Checked continuity from pin 19

Same boat here.? I ordered an OCX 80 about 3 weeks ago.? Got a serial number of 2211.? They are still at 1453.. At this rate I might be able to build it for next winter.? Or maybe winter

I used a plastic softball display case available from your nearby craft stores, usually less than $10 USD.? US Stores ALWAYS have discount coupons on their websites. ? The plastic can crack, when

Thanks Hans, I am sure everyone who is patiently waiting will be pleased to hear of the extra efforts that you and your team are putting in :-) 73 Simon G0FCU.

Hi Simon That's because your #1555 is in the block which was passed to my Tokyo friend for shipment! You should get the notification tomorrow I expect. 73 Hans G0UPL http://qrp-labs.com wrote:

Hi Simon Orders weren't outstripping shipping... but at the rate the mountain of pending orders was coming down, I wasn't confident we'd get back to the normal 3-days shipment rule for months! 73

...although unlike Ian (#1570) I haven't received shipping confirmation (#1555).

Thanks Ian & Hans, I have a close friend who ordered a 20 meter QCX awhile back. His serial# is in the 1800+ range and he keeps bugging me as if I would know when it would ship. I keep telling him

That's good to hear Hans, I am confident that 1555 (mine!) will be here soon :-) I was beginning to worry that with orders outstripping shipping you would never get to the end of the queue and you

Steve, There should be around 12V on the drain. 73 Alan G4ZFQ

Hello Alan, G4ZFQ, Thanks for the de-soldering tip. I have a hot-air gun, and am planning to use it. The foil technique to shield the other components is brilliant. I have been practicing

Hi Jim It hasn't stalled. On the contrary! It is taking a substantial jump. I got extra help in, to reduce the size of the backlog! Last Thursday, I got in touch with a friend of mine in Tokyo. He

Hi Jim I got an email few days ago saying Sno! 1570 was shipped. 73 Ian G4GIR Sent: Monday, December 4, 2017 4:30 PM To: [email protected] Subject: [QRPLabs] Shipping? Just wondering if shipping

Which legs do I check Alan?

Hi Antonio You must have been reading my mind!!! I thought the same thing. I have a 17mtr QCX which has had a lot of problems but I finally got the thing going. I had to change IC1 but that's

Right, had my U3S have 6 minutes calibration between transmissions over night. Still the frequency is 20Hz low when frequency display is reading 28.000.890 and still has the 20Hz power-on 'tail'.

Hi Antonio, I have a rough, untried paper design.? " bands is probably OK, as you can assign one band to vfoA, and the other to vfoB, otherwise you are in for a LOT of knob twiddling, or a factory

Just wondering if shipping is stalled again?? Haven't seen a QCX serial# shipping update since 11/30

Steve, Do you get any voltage on Q1, 2, 3 on TX? 73 Alan G4ZFQ

Gracias Luis! :) ahora mismo lo miro. 73