开云体育

I changed from 150,000,000 to 149,000,000 with no appreciable change and went to 075,000,000 and was still getting drift of 2 to 4 (on 20m), so it looks like something's not quite there.? I'm not

Thanks for the offer Steve. I may take you up on it. Bill N7EU's comment gave me a number to work with. Heading to the somewhat local, parts distributor tomorrow. See If I can find something suitable.

Removing the LPF toroids is difficult. Would an acceptable alternative fix be to short out 1 or 2 turns by soldering a short on the top of the toroid? What effect would the shorted turns have other

Hi Bill, No.? I used the specified turns and the trimmer capacitor tunes the inductor just about in the middle of the plate closure.? If I had had the #34 wire when I wound it, I would have used

At the risk of beating this horse to death, I built my 40m kit using the exact number of turns that the manual instructed. I'm getting a solid 4 watts out, using a 12v supply. I don't know about the

Do you mean small incremental changes, like the 149,000,000 figure mentioned elsewhere, or a more extreme setting, say halving the frequency? Will this disrupt the currently-proper drift on 40m??

Hi Kurt - I'm sorry but I can't give a recommendation but only my experience. I bought a Anet A8 kit from Gearbest.? It wasn't a challenge to assemble.? The prints I get are very usable.? The

Hans; Thank you for your quick response. Yes, that is exactly what I had in mind. I should have spent a little more time researching my thought. None the less this is perfect. 73; Kurt -

I built a plastic enclosure for my SW30 - A mitre saw with a fine blade will produce panels with square corners and I used pushnuts to fasten the lid to the box SW30 (

Ian Additionally to what others have said... On your image it seems that the gap between transmissions is well under one minute. Is this actually two consecutive transmissions or did you switch off

Hello Kurt Have a look at the QCX builder's gallery http://www.qrp-labs.com/qcx/qcxgallery.html and scroll down to the acrylic enclosure by Shig JA1XRQ. He made a nice PDF explaining all of it, and

I assume you are using a 'standard' QRP-Labs synth board and not the OCXO version. What Park Mode type are you using Ian? Examples: In mode 2 the park mode is inactive

So I don't have access to a 3d printer and what I've seen it is amazing. I have considered welding one together using a Polycarbonate material. Has anyone gone this route? With any success? Any

OK so I an new to 3d printing although I certainly understand the technology. What is the 3d printer of choice these daya? Thanks in advance. 73; Kurt - W2MW

I found the audio also too loud. But in a menu I reduce the volume to 70 %

Ian, Of course I am assuming you can hear the U3S on a local RX rather than a remote report?? 73 Alan G4ZFQ

Hi, I had my 20m QCX working perfectly, but after four or five cycles of WSPR TX the display went blank and the receiver stopped working. As I couldn't detect 5V anywhere I presumed the 7805

Ian, Have you tried with NO PA voltage? That looks more like a voltage change than temperature related. It seems to stabilise too quickly. Is that related? It looks as if it might start correctly

Ian Liston-Smith has shared a?OneDrive?file with you. To view it, click the link

Jim, ???? As far as you can tell, did using a smaller diameter wire change the number of turns at all?? I'd rather not have to desolder the primary to add or remove turns. Bill W2EB