开云体育

Have shorted the inductors as sugested but still no luck. Cant see any placement mistakes, and hve gone back over the back with the iron again. Still no change. Could it be a problem with one of the

My version of VK5EEE's story has to with surface mount components. I'm getting more familiar with the techniques, but in one case while holding a small SMD resistor with tweezers and getting it

Keith. A nice view of the "Polar Prince" in harbour. I've followed the cruise of the vessel at times in between my trips away. It would have been interesting to have been on this restful cruise myself

Hi Hans, You seem to be getting a lot of flak at the moment. I’d just like to say that I, probably like many others, really appreciate what you’ve done. Yes I had to wait a short while for my kit.

Try SMD kits where you need tweezers to mount the parts. Fun but you lose many parts to the carpet.

I'm impressed by your 4 place accuracy in measuring the pin flight distance. I just let mine fly and then vacuum the area once a year whether it needs it or not.

Hi Alex The QCX is a very complex system, in terms of all the firmware; and the hardware is not trivial either. I think it is normal that with a new product like this, there are some minor issues

wear glasses have fun 73, -bob ah7i

Mike, Reflashed the chip and it works again!!! Tried progressively lower values for C47 down through 220, 100, 47, 33, 22 until 10uf. ?Only when down to 10uf does it power on first time (and it

I've just carefully removed R19 and R25 and swapped them over. I can now achieve correct minimums for all three of the alignment steps :-) Now to go and see there is anyone on 17m :-) PeterO G0DZB

Oh Lou You really are a n00by but you will learn from the experience you are gaining and want to build more. At least you have a smooth floor mate wait until the clipped wire lands in the carpet,

Thanks Mike. C47 was one my suspects earlier so I replaced it with 220uf (my kit had 470uf). The lower value made no detectable difference. I pulled the chip and put it in an arduino uno and the IDE

I'm sure this will be obvious to most, but I'm in spite of my age a real n00b when it comes to building anything electronic, a joy it is too! When you use the wire cutters to cut one pin off, you may

Hi Simon I am building the 20M version. I had a issue with no display at power on, but it did come on at the second try. For your info my brightness pot is turned fully anticlockwise. I changed L6 to

Good evening dear Hans, OK I saw your e-mail and I will try to update soon and report you. But the WSPR decoded issue is wondering. Hidehiko.

Hi Alan I have now downloaded the AVRDUDESS zipped file, unzipped and tried to run it. However it looks like it is starting, but it flashes on the screen for a few milliseconds and disappears. Any

Hi Alan Thanks for the info. I am running W10 1703. When I try to download AVRDUDESS 2.4.exe I get "interrupted virus detected"? This is the site for the

Hi Ken, I don's suppose you could give us a quick run down of your jumper positions for that? Many Thanks 73 2E0IHH

Hello Hidehiko-san I already replied to you on this group, and by private message. I agree that CW-R does not work, and the beacon frequency appears while a message memory is being sent. I sent a

Tonight I try to transmit for the experimental of WSPR on 40m band but I found only a few stations plotting my 5W signal from QCX. With comparing FT920 5W transmit WSPR the QCX's WSPR transmit has