开云体育

Hi John To be clear: I think you have put in your callsign, locator and power into the Message setting. This is not what is needed for WSPR! You need: 1) "Mode" set to "WSPR" 2) Your callsign in

Hi John In that case, you have to put your callsign "M0ELS" into the "Callsign" setting, and it will be used for WSPR. 73 Hans G0UPL

I have just connected it up to my transverter and its running ok, excepting that I need more RF to drive the IRF510. I already have 2x BS170'S in use, but will need another two or so. Happy

Ok, Got it all running now, so now to get some RF into my transverter and see if it kicks over. 73 John ? Digitally signed mail - M0ELS

No space in? callsign window M0ELS, but put spaces in the message window? M0ELS JO01 27 73 John ? Digitally signed mail - M0ELS ________________________________ To:

Hi John The requirements on callsign entry for WSPR are on page 4 of the manual (v2.03). WSPR will try to take your callsign from the "Callsign" setting and will make sure it satisfies the listed

Hi John, Are you including a space after your suffix. If you are then take it out. 73"s De Andy ------------------------------

Trying to run the hardware in wspr mode, but keep getting error : message. Any ideas as it happens with no message or with one. CW mode brings up the clock >00 WHICH IS COUNTING DOWN i PRESUME TO TX

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the QRPLabs group. File : /Using the Ultimate 2 on 472 kHz with an external

Yesterday, I lost a whole day due to me reacting to an arthiritis drug, which I took the night before. Things are settling down now and scratching around, I found an old Navibe GPS unit ( looks like a

Been a bit quiet lately but looks like I'm back in business. I had 3 problems manifest themselves on about the same time which made me untold puzzlement and frustration. 1) PSU problem. U2 worked

The GPS is not needed to make WSPR work. All of my U2 WSPR work has been without a GPS. A few iterations of setting the 20 MHz oscillator frequency are required, but mine has run for more than a

Hi Tom I re-studied the code. The processor doesn't wait for any feedback from the DDS. It just talks to it and hopes it listens. However, it does expect communication back from the LCD! So this

Nobody claimed it yet! 73 Hans

Dear fellows, since I received the V2.02a firmware chip, I have one obsolete V2.01 processor in the shelf. I thought about using it as a standalone CW beacon keyer. So I set up a dummy board which

Any updates on the competition so far ? Did anyone already claim the U2 ? The 50 MHz short skip season is not yet over... Regards from sunny Bavaria, Tom, DL2WB

On 26/07/2013 22:11, Charlie , W5COV wrote: > > Barry , > > I plan to use one of mine on 472 kHz. also . Would you mind sharing your amplifier drawing ? > > Best Regards. > > 73 , Charlie , W5COV > >

Paul, From what you said, a variable PS just for the final or finals might be interesting. Use a LM-317 and pot for regulator. Bad news yesterday. Was going th use my old FV-M8 for the GPS. Data out

Got some 2.03 chips in the post this morning and now my trusty old Trimble GPS module is working again... Now I can run both U2 rigs under GPS control... Happy days Thanks Hans.. Philip

Question now is, shall I rewind them all to make them look neater? Nah! no chance :) Philip G4JVF