开云体育

I decided to be brave and do the SSB upgrade. Ran the full calibration with no problems but it made no difference at all to the any of the spurs every 500Hz on 6m with still the strongest on 1500Hz

Someone has mentioned before and you are not answered, are you try to set contrast with the trimmer pot?

Hi Dan, Powered down nicely, far too paranoid to just yank the power cable hehe. On the QMX, I left the center and filter settings to default. On my QCX, was not aware you could mess with the filter,

Ludwig, Now I am able to scan through the menu, here is the screenshot that you had requested. My QMX display is still yellow with 16 square doted squares along the upper margin. There must be an

Eben, The new filter settings should be saved when you shut down the QMX(+) with the left (top) knob long press. If you just pull the power it will not save anything. out of curiosity, did you redo

It is to expand the U3S (WSPR Tx) from single band to 6 bands. It plugs directly into the back of the U3S board. I believe there are some other uses for it, but that is the main one. You also have to

Need a sanity check here: Just built and installed T507 and as I was checking continuity between A-A, B-B, etc. I noticed that every pin would show continuity between each other (A shorts to BCD, B

Robert, I did something similar to what you are considering. Sounds like you might be envisioning the front panel mounted 90 deg CCW from mine. I'm attaching a couple pictures. I can supply more

Glad you got it working. Is the clicking coming out of a speaker/headphones?? Or out of the QMX itself? If from the QMX, that's probably not good.? None of the hardware should be making any

Installed the latest firmware. I prefer a lower sidetone, so tried setting both offset and sidetone freq to 600. Normally run 580Hz, but it looks like 600 is the minimum value. This does not seem to

Just for clarity...vox is *off*. Its working like a champ now and surprised, to be honest. Curious, what is that clicking? As far as I know the QMX has no relays? but hear a definite click on tx...

Pleading ignorance, please tell me where to find how to use one of these things. What does it fit in what other device? Is tthis part of a WSPR beacon? -- 73 Karl KI4ZUQ

Thanks!!! You don't know how much time I spent on this!!! I LOVE software.... Links: ------ [1] /g/QRPLabs/message/145548 [2] /mt/113168684/6032434 [3]

I would claim that I had a similar problem. I too was testing into a dummy load and monitoring vis another receiver. This was after many successful SSB contacts. But, also after numerous firmware

Stan, I have been transmitting into a dummy load and monitoring via a my shack base transceiver sitting on the same workbench.? Audio through the mic when doing this with the (tr)uSDX sounds fine but

Thanks, that makes a lot of sense now. I think you correctly understood that it was a misconception on my part about how the frequency shift worked worked.

Well, I found my DUMB mistake! I had the waterfall High and Low reversed! $#@!^&* 73, Randy? KS4L

I do this all the time.? I have multiple configs set, two for my Elecraft K3 (field day vs. normal), one for my Yaesu 991/A, and one for my QMX. Works fine. Regarding the connection problem - which

First question, are there issues running several different radios on WSJTX by switching configurations? I had WSJTX set up so I could switch to an IC-7100, IC-7300 or QMX+, it was working fine when

I found a note in the telepostinc website about clicking on the NaP3 display to set frequency. First click with the right mouse button and zero-in on the signal or frequency of interest, then click