开云体育

If your qmx+ turns the display backlight on, and displays anything on the display, it is quite unlikely that there was a problem transferring the firmware.? This is because diverse sections of the

Thanks, Stan, I'll do that again. It does not seem intermittent because of the regularity of the hanging. It seems the firmware image is not being accepted (fully or accurately) or it is not being

Thanks Hans, I had wondered if it was related to the frequency. Your explanation makes sense. ? I wanted to note that I have experienced that both "," and "." are omitted in the CAT response no

I reran the calibration routines with 1_01_007 on my high band QMX. ? The results mostly mirrored the results I got with 1_01_003 with the exception of 10m USB sync where I got a straight line at

" The change >30 degrees was in fact a measurement of 0.1 following a measurement of 359.8, so it was a phase rollover, not a large change." I wonder if this could be the root cause of calibration

Interesting, Paul.? That does not happen on my Win10 machine; any process can use any of three ports in any order.? If I start WSJT-x second, I just have to change it to the second or third port,

Erm, I bet you've used the PC version of WSPR / WSJTX and applies the dial freq to your SSB rig, and then used the same dial freq on a U3S ? Nah, U3S uses direct freq mode, RTFM. So if you're using

Thanks everyone. i will see if i can find some. 72 johnny AC?BQ

Just had another instance of phase error calibration ending early, at DAC=750. This time it was on the 6m band, as part of a full 'R' calibration of all bands on my QMX+ r3. All other bands completed

Wow, that was easy. Thanks.

Nope. Wrong link https://www.aliexpress.com/item/1005008634695204.html?

The top isn't doing anything except making it easier to wind . .? ? ?This been repeatedly stated on here

I'm going to add these to my next Aliexpress order to see if they are a match... https://www.aliexpress.com/item/1005002090028747.html? 72 de Russ, va3rr

I've checked out 1_01_007 on my Intel iMac running MacOS 15.4.1. ?When all 3 serial ports enabled, they appear

Moritz, this happens often on one or more of my 4 QMX*, but not always,? often it works correctly.? ?Something similar can also happen when going into firmware update mode, where you need to push

There is no issue with this, Rod.? The brittle tops of those coils often break, but that doesn't affect performance. Stan KC7XE

m2.5 /g/QRPLabs/message/127768

Angelo, maybe you find some information when reading QMX QMX_plus SSB settings ( /g/QRPLabs/wiki/38982 ). 73 Ludwig

I? just used the Baofeng as in the picture above this message ...! No joy at all ... I have also tried to use another electrect bought from AliExpress ..same story. It seems the micro try to send

M2.5 5mm I think.? I've got a bag full but sending a few from the UK will probably be more expensive than getting them on Ebay.