开云体育

I've checked out 1_01_007 on my Intel iMac running MacOS 15.4.1. ?When all 3 serial ports enabled, they appear

Moritz, this happens often on one or more of my 4 QMX*, but not always,? often it works correctly.? ?Something similar can also happen when going into firmware update mode, where you need to push

There is no issue with this, Rod.? The brittle tops of those coils often break, but that doesn't affect performance. Stan KC7XE

m2.5 /g/QRPLabs/message/127768

Angelo, maybe you find some information when reading QMX QMX_plus SSB settings ( /g/QRPLabs/wiki/38982 ). 73 Ludwig

I? just used the Baofeng as in the picture above this message ...! No joy at all ... I have also tried to use another electrect bought from AliExpress ..same story. It seems the micro try to send

M2.5 5mm I think.? I've got a bag full but sending a few from the UK will probably be more expensive than getting them on Ebay.

HI Mike, Yeah I've often heard of this over the years, but oddly enough never seen it myself. (Yeah, got a truck load of HT's and accessories to satisfy my fetish) ;-) As you say, worth checking

In the WSJT-X Settings / Radio tab there is a section called "Mode" which by default is set to USB. This means WSJT-X will try to put the radio into USB mode. When there was no USB mode in QMX the

Good afternoon I just finished a QMX build and I am missing two of the case screws. They are the black bevel head Phillips screws. Does any happen to know what size and Thread these are. Thanks Johnny

Hello smart people, So I assembled an Ultimate 3s WSPR kit. I booted it up, hooked it up to a dummy load, and everything worked as it should. But then, a thought. What am I supposed to do for an

I'll also confirm that _007 is working on Windows 10 Home with my QMX+.. I can see 3 COM ports, COM8 (the original one), COM 22 and COM23. Also see the audio ports. I ran the full SSB Cal. on COM23,

Hello everyone. I finally got around to starting my QMX+ build and noticed that a piece of the top of L101 has broken off. I would guess about 25 to 30 percent of the top is missing. I did not find

Hi Adam Yes, unforeseen side-effect of the way CAT is implemented. in QMX the thousands separator can be set to ',' (UK/US/etc style) or '.' (European/etc style) by a setting. CAT replies ignore any

Hi Sergey I could... but, it would take unnecessary time, and, I believe you! I suppose VARA just isn't putting out full volume. QMX in SSB mode is set up so that full volume from the PC means full

Hello Moritz This problem is not a new one with the SSB firmware. It may well be related to the issue that you have to power on your PC, before you power up your QMX. On Windows. Again something that

playing around with the LC; CAT command.... if there are "." on the cw decoder, the LC command does not display them.?? Instead of outputting 32 characters you get less and less the more periods

I have a newly built QMX+. Still on the dummy load. 1_01_007 beta firmware. I'm attempting to measure power output using WSJT-X in Tune mode. I've done this before with a QDX and a QMX. I cloned my

Beta 07 works fine with Win 10. All three COM ports can be enabled. Not so with Win 8. It sees only two ports no matter will one choose 2 or 3 in QMX menu. And there are no CAT control in WJST-X or

And here starts the whole description /g/QRPLabs/message/143940. 73 Ludwig