开云体育

I know that he built it for 9v, same as mine. I know that one can choose to build it for 12v input by a small change in the winding of a toroid. I do not know why the components after said toroid

Sepehr, you could use this cheap converter whill will give you a steady 9V:

Packing up my rig etc and closing down here in Oak Island ( OKI ), North Carolina and heading back to the New River Valley of Virginia this week. So, I just had to break out the clip leads one more

The device can be built to either handle 12v or handle 9v; the person asking the question here built their radio (the transformer part, specifically) for 9v. 73 -- Matt N3AR

There doesn’t seem to be a clear consistent answer, the manual implies “a little over” is OK but does not define “little”. I admit that I don’t understand how a device that can handle 12v

You could use 2- 7809's in parallel for added current rating or 1-78S09, which I think is good for 2 amps by itself. Your input voltage just needs to 3 or 4 volts higher then the needed output

You could put a small buck converter or a couple of diodes in the line to drop the voltage into acceptable range. -- 73, Dan - W2DLC

I wouldn't use FT8, but CW into a well-matched antenna might be ok... XE3/VA3RR

Hello, I have a QMX that is built for 9V. Now I'm making a custom LiFePO4 battery for it. My question is, what's the maximum input voltage that the QMX can handle before it breaks? Given that each

Apparently this microphone works best: /g/QRPLabs/message/141854 Jerry, KE7ER

Chris, Not clear what you were doing there. Strikes me as a very bad idea to apply reverse power to the QMX from your power supply, if that is what you did. You could wind up with a whole bunch more

Hi Jim, wrong, 0 mA in this state and around 200 mA for a part of a second when firmware is running and for the whole time in firmware update mode. You may read QMX QMX_plus Startup (

I would be surprised if this connection is broken.

Hi Azgael, yes, drain of Q102 and VI of IC101 must show the same voltage. But 5 V at drain of Q101 is strange. If the controller doesn't work the gate of Q101 is pulled to 50 % of "+12V", so here

Han, fine if I could get a little help. And you made good investigations to find the problem, well done! Thank you also for this information. 73 Ludwig

When left encoder is pressed? How did you test the SMPS boards, using the method from the QRP Labs Wiki? When the controller isn't running, LIN_REG_EN is pulled to 50% of "+12V". With 10 V in it

Hi Fred I expect WSJT-X is querying and setting the radio via CAT commands. I should change that! Consider it added to my list! 73 Hans

Thank you, that is the plan. Just waiting on the wire to arrive. 73 Doug WB5WRC

https://www.youtube.com/watch?v=YCL3FjQ2WV4 The QMX puts out 10 MHz, a transverter converts up to 10 GHz

SO i had a working qmx rev 2 - purchased assembled - i was swapping my antenna coax from another radio and poof the QMX no longer powers up . I also had a kit so i swapped out the PS boards . Still no