开云体育

Purely a firmware thing, I believe. When/if the BASIC comes, I want to customize the UI so that a single click of the left encoder puts the QMX into band select mode and you choose the band by

Thank you Brian I was thinking about that and I will definitely give it a try. Thank you

Hi. You are logically inconsistent.? If I have 3 points A,B,C and A connects to C, and B connects to C, then A and B MUST show continuity to each other. I suggest you check your

You won't have continuity between all the P points UNTIL you twist those 2 P leads together. This threw me as well for a bit.

No point to clean out the holes when replacing the BS170's, about all that does is damage the board with all the heat. Just clip the new leads short and lay them flat across the top of the holes,

I managed to get through the steps to build the RWTST version of the transformer. I'm getting caught up on Step 14: I have continuity between the secondaries. I also have continuity between the

Thank you for kindly answering my question... I truly appreciate it. I suppose I could have known that Hans already addressed this, but I admit that I have been unable to keep up with messages. I

Sometimes if the knobs are installed with not enough clearance for full down travel you can get double clicks.? If this seems like a possibility, try raising the knobs on the shaft a little. Brien

Rather than use the microphone input I have been running Fldigi into the USB and having some nice QSOs on Olivia. Olivia has amplitude modulation of the envelope (unlike wspr or ft8) due to how the

IIRC, Hans already has stated that the calibration must be done at full power, which makes sense as it is a way of measuring, and compensating for, the non-linearity inherent in the final amplifier

Joel, I calibrated mine at 11.1 volts, battery voltage dropped with 3 diodes in series and it all went well. I continue to operate at that voltage and the output is slightly lower than it was at 12

I had the same thing happen... QMX+ is on the bench with the BS170's removed, and one of them indeed tested bad. While waiting on my replacement BS170's I am carefully cleaning out the holes. I really

QMX… I have the SSB software installed version three and made one contact with good audio reports. The only thing that is strange is sometimes the radio does not go into transmit when I press the

Jack, I have been having a similar issue, and found I got wider. smoother curves on 80 meters with my QMX+ if I configured the band edges closer to the actual legal band edged, then set the center

Very often when I do a Single click to change mode it changes band instead. I was wondering if there’s something I can do to improve the situation. ?Is this a hardware issue or a firmware issue? Is

Hey Scott, we're practically neighbors! We should get together to compare notes over coffee or something. It would be good to do some audio quality QSOs with you because you're local! Mario

Hello Hans! My QMX works great with 1_01_003 firmware. I've calibrated it and SSB reports are very good. Thanks! Few problems: 1. Wattmeter indicator looks like very slowly responding to actual power

I'm still getting a weird phase error plot on 80m. It stops at 36%.? U shaped with near right angles at the corners. I tried adjusting the band config parameters, moving the centre Freq around. Still

I forgot to add that with the changed centre frequency and smoother plot on 20m, the transmitted audio sounds as good as the other bands now. Cheers, Glenn VK3YY.

Adam,? I had a similar wierd short plot on 20m (see earlier post on earlier beta thread with audio clips) which resulted in distorted transmit audio on 20m only (the other bands were good).? I found