开云体育

There is plenty of 10m activity on FT8 right now, at least where I am.? Check your audio card settings. Stan KC7XE

Would any of you happen to know what these vertical lines are on the waterfall? I'm trying to do a Winlink P2P connection with a friend 30 miles away via NVIS and noticed these lines would sometimes

Is 10m active today? Because I get around 3w out but I hear nothing on ft8

Hi Stan Thanks for the pointers. I got hold of a current-limiting PSU, and did the tests suggested in the wiki here: /g/QRPLabs/wiki/37128 on PCB#1: step 2, I got Vcc = 4.1v

Roger great to hear its working! Thanks for sharing. Your picture got me curious - what antenna are you using with the tuner and Elecraft balun? 73 KD2WQI [email protected]> wrote:

About the best option for sharing physical COMM ports is using TCP/IP. WSJT-X has a radio option for it, and most logging programs will also connect to it. There is also a hardware option - create

Got your order, Glen. Also sent you a private message John. My bubble mailers didn't show up Saturday like they were supposed to, Amazon is telling me they should show up by Tuesday, so it looks like

I try to repurpose that stuff all the time. Did it have that ribbon wire in it? Thats the wire with laquered ribbon wrapped on some kind of poly thread that's? impossible to solder; found in most ear

Either way would have been fine. Releasing SSB firmware for 80m only, no CESS, limited menu, no support for CW or digital modes, no calibration step would have shut down the "This EER SSB Stuff Can't

Hans: I tried changing the 80/20 band swap advanced setting and it didn't fix the problem, but it changed the behavior a lot. It now runs longer before quitting. In another thread, others with this

I found the setting in the second page of the Advanced configuration menu. It changed things (it runs longer now), but didn't fix them: M

My version 1 PCB installed an earlier band table with the band centers on the FT8 Frequencies. I'm having this sort of trouble on 80 and 40 meters. I think there may be a problem if the test

Erik, I also would like one kit in Black.? Sent you an email also, please advise how you would like to be paid by return email. Glen, WB4KTF, Austin, TX wb4ktf@... -- 73s, Glen, WB4KTF,

Also duplicated this exact same issue. I spent time trouble shooting but found no solution and now just switch to Digi when needed.

At first I tried clicking the "Update hamlib" button in WSJTX. This did not fix the issue. So I copied over the latest manually. WSJTX will now allow me to select the

Hamlib 4.6.2 or better if you want QMX support. Hamlib. 4.6.1 is BROKEN!

Does this occur when transmitting into a dummy load? 73, Don N2VGU

Well said John. I agree with you. Mike Krieger [email protected]> wrote:

Peter, Good idea! I think you have a winning idea. Altho the 60-15 m version is the sweet spot for me. -- 73, Dan? NM3A

The advantage of USB mode over DIGI mode is the ability to control the power level. DIGI is my preferred mode but there are times when reduced power is