开云体育

Mine is doing this as well. -- 73, Dan - W2DLC

That update 'hanging' happened with the prior two releases on a couple of my units. I don't believe it is related to the new firmware; it is something that has always been there; just happens

I had the same experience as Adam although I didn't wait for mine to disconnect, I just pulled power after the QMX hung. Power cycled and booted up fine. Then I went back into firmware update to

Contact Jeff Moore W1NC. He has repaired many QMX and QMX + rigs. You will see many positive posts regarding his work. Mike Krieger [email protected]> wrote:

Typically when I move new firmware over, after the file finishes copying, the drive disconnects, and the device reboots.? When loading 003, it hung for about 5-8min before the drive disconnected, and

Still waiting for some parts to come in from digikey.? In the meantime, I have been making contacts across the bands with some earbuds that have an integrated mic plugged into my compute.? the QMX

Hello, Anyone out there do repairs on a QMX? I don't have the technical skills to do the work myself. Radio was functioning as normal until I attempted the SSB beta firmware. After that, the digi

Odd, I see something similar via my Hermes Lite 2.

As FDM parts, I assume you're printing an array of multiples on your buildplate, Erik. They are not very tall so, depending your your printer architecture, you might even be able to print a tightly

I need display and its mounting board for qmx. ?Is this offered as spare parts. ? I see it for qcx. ?I have the mid version of qmx. KJ5IVB ….Bill

yes, external mic

With this release - still external microphone must used - right? -- 73, Sardar (AC8L, 4K6SA, VA3DUA).

That's the most clever I have seen yet! Thanks for sharing!

How about an old lineman test key with a built in mic? Quick switch from CW to SSB just by changing the mode and holding the key up like a mic!

Just tried this and was able to run calibration from the front panel with USB disconnected. Interesting results. My QMX+ has TN0110 finals so I was expecting possible issues with calibration. When I

My workbench this weekend, assembling them as fast as the printer can print them:

A work in progress... It uses the front panel from a QCX.? The controller is a 68HC11 SBC from Axiom.? My daughter used the board for a collage course and gave it to me many years ago.

This radio is a solar powered WSPR transmitter.? It has a QRP labs arduino shield, PIC16F690 controller, a dds module, a high side switch to control power to the transmitter parts.? It uses a WWVB

Brein, Your settings are nearly identical with what I arrived at except that I did engage EQ, but it isn't really necessary unless you change the TX filter upper and lower limits. With a flat

I tried to use up some parts on hand for projects this winter.? This radio has a QRP-Labs arduino shield, a QRP-Labs receiver module, Teensy LC controller, Nokia display, Rtc clock for time keeping,