开云体育

Hello Hans and others, I just uploaded the new firmware and am trying to get Winlink / VARA-HF working. Are there any specific settings that need to be adjusted? When CAT control supposedly keys up

I just got a Baofeng ht spkr mic. ?Going to clip the spkr lead on the cable so no load if it makes contact upon insertion. The 3.5mm is a 4 contact but it appears to have the correct tip to Gnd and

I've also loaded 1_01_002 and I have low output on FT8 and CW. I've also noticed I've had to turn the RF gain almost up to 100. I'm getting about 1.5 watts out, and the QMX is getting hot to the

Bug found with Beta 002 firmware: In SSB Mode, using CAT control for PTT, if I include an intentional delay of about 50 ms or more between switching to TX and beginning to provide output audio via

I had a similar problem - after my build i got the USB drive, loaded the firmware, which seemed to load, but then absolutely nothing.? Forced back into USB drive and the firmware was there.?

We had fourteen folks join the MI QRP Zoom Chat on 20 March. Please join us Thursday March 27 (and every Thursday) at 4PM Eastern for the Michigan QRP Club weekly QRP Chat where the main topics will

Going to Terminal - Configuration - SSB - Transmit EQ and changing a parameter it looks like the terminal is frozen. But there is something going on in the background, maybe calculations to display

I loaded the Beta 002 and the splash screen is still showing 2024. -- 73, Dan - W2DLC

I have also noted the issue that Joel N6ALT reported above.? After loading version 1_01_002 and running the calibration routine, the output level in Digital Modes has dropped roughly in

I don't have attenuators handy and ready, so I disconnected the antenna from my IC-7300 and let it pick up that way.? Might try again through a dummy load, but needless to say, there are issues on

Thank you Eric, and thank you Adam! My housing is printed and I await the fiddly bits!

I made a simple adapter that crosses tip and ring from a jack and a short length of cord and plug so that I can use any several mics I already have. -- 73 KD8CGH

I have had a really good response to this offer to kit together the mics, and with Adam's approval ('cuz it's his mic design) I have ordered more parts so the limit of 9 has as of now been removed. If

Stan, I noticed that while calibrating my QMX+, I had a amplified speaker plugged into it while calibrating, some were only a single tone and some were two tone. Don't know what it all

I ran out of PINK!! Maybe glow in the dark green... :P Erik

I installed Firmware beta 1_01_002 on my high band QMX. In putty I started Optimization and after less then a minute putty became unresponsive. I exited putty and disconnected power from the QMX. I

Chris, I built it for 12V, so that's what I calibrated it at per Hans advice. It seems low in power now, I think the highest power I'm getting is about 1.5 watts, I was getting about 3 watts before.

Erik I just sent money for a microphone. Please pick out a very macho color for me. Address is good in the PayPal or on QRZ. Bill

Well, I finally got it calibrated, not sure what all the numbers meant but it's done. Joel N6ALT

I've done two calibrations and both ran to completion. I was running at less than full power, 10V on a 12V QMX. What voltage were you using?? Did you have a dummy load that gives close to 1:1