开云体育

Chuck, Regardless of software definition or not, the hardware will have variations, and your ears will have variations, and band conditions will vary. Your AGC will respond to those variables

On 1/6/25 I had a CW practice / rag chew session on 30 meters. I worked two stations: Date / Time Call Bnd Frequency Mode Power Rec Snt Name SPC# Comments 1/6/2025 14:57 AA0YY 30 10.108

I have a freshly minted QMX+ and I am experiencing the same problem.? CW seems to work fine.? FT8 was working last evening but then suddenly stopped. Now when I hit tune or try to transmit, it

Since the AGC settings seem to be very dependent on the ambient noise on the band, it would be helpful for me to know on which band the settings are optimal, and what level the ambient noise is when

Steve - I was actually rereading the posts last week, and I adjusted my settings to be somewhat the same as yours. Here's what I compiled from a couple of threads - I apologize for not accrediting a

I thought the whole point of using SDR's was to eliminate most of the difference between examples of a given radio. W1AW works perfectly with just about any AGC setting here at my location... mostly

The radio is a Ver. 1 QMX plus that in general performs exactly like I expect.? It does not have the GPS option installed, and there is no battery in the clock battery slot.? The radio is used for

Hi Stan, Hi All, here a success message. After yesterdays experiment running QMX direct from 3.3V and getting confirmed CPU and rest of 3.3V Rail OK, I spend all evening/night rechecking QMX over

Great YouTube video, thanks for sharing. Mike Krieger [email protected]> wrote:

Really, it depends on you and your ears, and the differences from radio to radio. Things are not all going to be equal. The default settings were chosen because they are a good starting point. That

Note that there is no LPF filtering on the MiniKits amp. Just sayin’. 73, Robert, WA2T

I've experimented with the filters a bit and I just leave it on 500Hz.? The filter control is not a QMX strength.? What would be wonderful is a cw mode that gave you top-level control of the filters

Yes of course, my page should only be an additional support and help, not a replacement of existing procedures. I'm looking forward to the next event :-)

Hi Jay Joe N2DI has a very informative video regarding this subject on YouTube. https://youtu.be/xDB-2Mlg9tg?si=1X_97ycqc0czjviT Personally, I waiting for a filter bandwidth of around 1500Hz for

Ok, changed. If it changes again please send ma an E-Mail, I don't always read along here.

I would like to have Luc's reminders also in future and then hang on the discord page which is nice if propagation is not with us just to know who is around.? Anyhow I am looking forward to a QSO

Lol, It was the last one in the log, on QO-100, been working them /mm for the grids. 73 Ian G4GIR,

Nice work Tom, but please check the way you determine the dates. The WARC Party is always *two weeks before* the Challenge, so for this month it's next week , January 13th, not the 20th I know it's

It is also safe to use one of the 3V smps cards from either of your other two kits, now that you have shown the main board does not have a 3.3V short. After doing that, and verifying no problems, you

The Bioenno has a full-charge voltage of 10.8V This will be too high for a 9V QMX, unless you use at least 2 diodes to drop the voltage.? Or avoid transmitting until the voltage drops to near 9V.?