开云体育

Was the power smooth enough to run a radio on?

Congratulations, QRP Labs and their rigs are very addicting! ?I enjoy many days operating on my collection…still use the original QCX and it’s wonderful built in key. ?I find great joy in using

Hi John Did you operate FT8 ? 73 Dirk

It seems the data is getting to the LCD. If the LCD has 5 volts on the pins it should have and the ground pins are at 0 volts then suspect the LCD. 73 Alan G4ZFQ

Hello, Happy to listen my first CQ CQ :) I wanna say thank you to all of you, even if Hans documentation is awesome, your support helps me alot. I believe now, it's time to work on the

I have not been able to configure fldigi on Windows 10 to work with QMX+. WSJT-X has been working just fine. Can anyone suggest the correct settings? Hiroki AH6CY

Hi Aki, Many many thanks for your help and your time! I'll try to get this little part. 73 Roland

/g/QRPLabs/message/135442

I have a spare pair of boards but I am in AU. Cheers David

I'm a senior senior, and it's healthy mental exercise trying to remember the button functions. (Not really, please label!!!)

In the QCX troubleshooting info they have you check the pot by making sure the voltage on lcd pin 3 sweeps from 0 to 5v as you turn the pot through a full turn.? I did this and confirmed I am getting

I have successfully replaced diodes on those little boards, and in the wiki here there is a description of how to do stand-alone testing on them. /g/QRPLabs/wiki/37128 But it is

My QMX-Plus order was updated on Dec 5, Dec 13 and Dec 16.? Moving up from #222 to #156 in the list. Mark, K9TR.

Yes, one of the connections on the little trimmer pot could indeed cause that issue, as could R304 - a tiny 3.3k resistor.? Make sure it is still in place and didn't get dislodged. Stan

I've a similar thing with a QMX.? What sort of power is it drawing in the post off state?

Steve, I'm certainly impressed by your QRPp results! My indoor z shaped dipole on the 2nd floor bedroom ceiling does not help me much on QRP CW.? Walls and ceilings here are stucco so have an

I just finished building a version 5 QDX unit.? The build went very well and I'm sure there are no poor solder connections as I checked every connection with a VOM after doing the soldering.? All

Finished building QMX+.? All seems well except that when pressing the encoder to shut down. I get the Shut Down Msg, it goes away, but the LCD still stays lit. Once that happens the encoder no longer

HI Karl, Honestly I felt like i had already checked that off but I know I don't know anywhere near enough so I opened it back up and was just going to do as you said realllly slow so I could fully

It would be a bit of a fluke if it were as accurate as a Fluke (pardon the dad humour). But for 6 ca$ delivered, I can't complain....