开云体育

I love my QMX+. How did you tune the antenna? What computer were you using? Mike Krieger [email protected]> wrote:

Paul K7VIQ ( /g/QRPLabs/message/135019 ) Dec 6 I am 64 so not the top 50, but getting closer.? QMX+ order 91594.? The main bands I hope work well are:? 10-40 meters.? Getting

I do not use a separate flux, but the solder I use has it inherently (if that is the correct term). So I do not know what type of flux it uses, and just hope it is of a good type. However, untill I

No point working that hard to clean holes of high temp solder.? Just clip out the old part and solder the new wire leads to the pads. I seldom find need to use other than isopropyl alcohol to clean

I added a 100uF capacitor in the location shown below, which works very well indeed. The remaining percussive element to the sidetone, which appears to get worse with increasing speed, is a hearing

And I still have my QRSS!

It's possible to use de-solder braid, solder suckers,? stainless steel pins,? high temperature enamelled wire (not easy solder stuff) and even a drinking straw to blow the solder through.? ? ?

In installing the capacitors I realized I misplaced one of them. Removing it was hell. Worse, one of the holes remained full of solder and there was no way I could clear it with a suction pump (or

I put a U3S Transceiver into service quite recently. For all it's 'old school' limitations it does what it does very well, very simply, very independently and very reliably. I have a lot of time for

Forgot to say that we had just arrived at our winter home in Oak Island ( OKI ) North Carolina and, Martha didn't want me to mess around outside because we needed to unload the car *AND* the truck

I worked Stuart, VE3STY, in Elizabethtown, Ontario, Canada on 40 meters FT8, using the improvised antenna, shown in the attached photo. I gotta tell ya, One QMX-PLUS, TWO modes ( going on THREE ) and

I still have a 'Simple QRSS Transmitter' here somewhere. That terrible LCD display ;-)

God help you! 7 Ara 2024 Cmt 14:37 tarihinde Hans Summers via groups.io <hans.summers= [email protected]> ?unu yazd?:

" then magnetic tape etc...... Enter the digital age where you can get a tiny card (a micro sd card)" Yes, try finding something to read that magnetic data now, or even try finding a CF reader. That

Hello all A shipping update... We did run out of a few things, and as usual it all seemed to happen at the same time. We did NOT run out of QDX, QMX and QMX+ but I'm manufacturing 500, 1000 and 1000

Hi Steve, The power readings you wanted for all the units. 73 Ian

:-) Super Hans I think I first came accros QRP labs when a local showed me his WSPR kit that was one of the Ultimate range. Im waiting for a 3D to finish and was taking the time to read through all

Ok Nick Better now? http://groups.io/g/qrplabs Ultimate3 wasn't the start though. First there was the simple QRSS transmitter kit that debutted at Dayton FDIM 2010. Then Ultimate, Ultiimat2,

Thanks everyone for your thoughts. A small plastic bag fastened to the case will work for me. Be the REASON someone smiles today. Dave K8WPE

I do not usually go to the cover page of the group but I noticed that its got a picture of the Ultimate 3 This is probably what started everything,... otr if not was how I first heard of QRP labs. How