开云体育

I too had a problem with output fluctuation. I found that with a 9V supply the problem went away. I must have made a mistake when wrapping the T501.

Has anyone ever tried to install a smaller LCD display in a qmx. Is there any experience with this? Which one can i use? like this one https://a.aliexpress.com/_Ew3iRHL 73' de dl9tx

The cleaning process will direct your attention to each area, kind of like hand-washing your car will allow you to find those little dings and scratches you would never have noticed if using the car

A scalpel blade, specifically a #15 blade, applied with a rocking motion adjacent to the IC body, will slice cleanly through the leads without putting undue stress on the PCB lands. Then merely

I took Jeff Moore's advice and bought a pint of 99% isopropyl alcohol from Amazon ( about $9).Much better than even 91%.? A little goes a long way. Really cleans quick and leaves little or no smeary

Digikey or Mouser are good sources. Shipping and handling will likely be more than the parts you buy, but stocking up on regular spares, general kit building supplies and such at the same time that

A soldering station with hot air is affordable and worth having.? ?I use YIHUA 8786D

Hi all, I’m interested in using a QMX with transverters for 4 meters/ 2 meters and 70 cms. But there seems to be a lack of modern DIY kits or designs for them. Any suggestions? My FT817 has

Your comments are greatly appreciated!!!! 72 Luis <va3cjo@...> escribió:

Due to damage I caused (small crack)? I need to replace the 180pf cap in my QMX + build. Can anyone please link a reliable source where I can purchase one and a few spares? The Shop doesn't list

p.s. to my prior post: oops, my QMX is built for 9V, so 125mA at 9V is about the same as 90mV at 12V from the prior posts.? So you do have a higher than normal idle current draw. But since you are

'Flux rarely causes a problem during the warranty period - especially the no-clean stuff' But years-on in certain circumstances of temperature and humidity it can become a problem for RF and power

I wouldn't assume you have a problem in the BS170s. My newly built QMX mini draws 125mA on idle/receive, and all diagnostic tests work correctly, and it seems to receive and transmit correctly.?

Others already pointed you to the right adaptors. I'll add that I often use iFTx with an iPhone and it works well, with a caveat: Apple places artificial limitations on the iPhone and it won't do CAT

Isopropyl alcohol works well and I prefer brands containing 99%. I use cotton swabs soaked in alcohol to clean around pads. The wet end does the cleaning and then I use the dry end to wipe up the

Also, as I understand it, simple rubbing alcohol suffices as flux-cleaner, so it's not a big deal. I've been using alcohol-wipe pads I had on hand (being careful not to leave behind fibers from the

Roy, thank you. That fits, so far, with what people seem to describe as part of the cluster of issues around the BS170s. Honestly, even if the BS170s turn out not to be the problem, starting with them

FT8cn is even more frustrating [email protected]> escribió:

It’s not absolutely necessary to remove flux but I be always do for two reasons. First, long term, flux could affect the performance of high-impedance points, most notably at RF frequencies. Second,

I am going to start building a QMX+. I was wondering if removing flux with a chemical is necessary? ?In all the builds I have done before I never bothered to try to remove the flux after finishing.