开云体育

Donald pointed these out and I've used them for decades in aviation and other uses. https://www.amazon.com/CONNECTIVITY-320555-TERMINAL-DISCONNECT-SPLICE/dp/B00MMZ0QUU Knife disconnect splice.?

All, I'm a bit embarrassed to say the issue was "operator error".? SKCC Logger queries VFO A.? I was inadvertently using VFO B to operate.? Thus, the freq never changed except when I changed bands

Hi Mark Reducing the threshold isn't the correct solution. You should set all the volumes on the computer to 100%. Application (WSJT-X slider), device volume and master volume. 73 Hans

Garth if that is true then the antenna is not presenting 50 ohms and the SWR on the line exists. However at some frequencies with antenna mismatch varying the line length can alter the presented?

Mark, So you have not seen the relaxed pulses of TX.. Hans was particularly pleased when he wrote that gentle display. It replaced the rapid 3 flashes because others complained they could not be sure

I was thinking along those lines recently, how an awkward length of coax feeder can cause high SWR on some bands. Were such things available then a 2-pole 2-way coax switch could be used to switch

Shoot! It is actually 2 flashes that I am seeing. I fat-fingered that. I am getting audio, just not enough to TX. I am also running FW 1_10, for what it's worth. I will try lowering the

Have you considered using traps instead of quick connections?? With traps you don't have to do anything to the antenna when changing bands, allowing frequent and rapid band

Trigger cables? Not so far. I suspect another noise source.

OK Hans:-) Sorry. I just did not think of firmware, the gentle pulse was introduced long ago, I thought everyone would have updated. I should remember, I was the one who asked for the 3 flashes to be

Don, I've had the opportunity to use that...? Quote from my report. We were testing the high power amp (audio 3KW) and we had the opportunity to witness a spectacular deflagration and

Don, the QCX mini has a local oscillator for the receiver that’s 700 Hz away from the transmit frequency. It is strong enough to hear on local receivers but not strong enough to travel any distance

Bill, The computer lost connection with the radio and just displays the last information it got. Try reconnecting. In the radio setup click on the read VFO button to make sure you have a

There are some inexpensive components used in mains and industrial wiring called "Ferrules". These are small tubes that are crimped on wires to reinforce them before using them with screw down

Donald S Brant Jr wrote: "At a to-remain-nameless former employer, people started reporting a lot of "problems" regarding a certain program. Management felt that this usage tended to foster a negative

Have you found these cables to be noisy? ?I have one and it’s terrible. I guess it could be the power bank.

Thomas, I’ve been playing with my U4B and have found a possible gotcha:- Connected to external power only Tx ok Connected to USB power only, Terminal not selected. No Tx USB power, program

Hi Alan This is the problem, not enough audio. Nothing else causes the flashing. But he said he has 3 flashes. On the older QDX firmware that means enough audio, on the newer firmware the LED would

My choice: 12V and feed with a buck/boost 4amp switching regulator with voltage and current limit pots FTW? Cheap on Amazon, it takes 7-30Vdc And will output anywhere within that range. I do find

Thomas, It looks as if something could be wrong with the Si5351 as you suggest. Possibly the firmware could have been corrupted, in which case a Factory Reset may cure the problem. Good luck and