开云体育

Hi all I don't know of anything that could cause higher current consumption (and heating) in 1_00_026. The higher CPU load in CPU was also the case in earlier versions with the single choice of CW

The only other difference that I noticed is a slightly higher CPU load of 39..40% on RX. Maybe a result of the new CW filters? It used to be around 33%.

PS: SMPS status on diagnostics mode looks good though...

Another vote for 3 x 18650 cells. They're perfect for the job. I must admit to being a bit less cautious than the others regarding final charge voltage. When the cells are straight out of the charger,

Peter, you may be right: for RX I just measured 122.35mA on my 9V Midband QMX in CW-Mode and 122.62mA in Digi-Mode. No USB/Cat was attached, no paddle, etc., only a linear PSU and a dummy load. On

I have managed to complete the update but had to short the two pins as described in the operating manual. It didn't re-boot but powering down and then on again I was pleased to see it start as normal.

I had the same results some time ago. The issue seems to be caused by the Android operating system trying to create various files and folders on the QMX drive which it doesn't take kindly to. In my

Yes, here the same 3x 18650 which I charge with a small foldable 20W solar panel. The charge voltage is kept to 12.2 Volt with a LM2596 step down voltage converter ( with display). Have fun with QRP.

Hello, I originaly did the same with my macbok pro, but the ctrl+Q does'nt work for me (and cmd+Q stop the terminal). So I use putty. -- ----- Regards, Stéphan.

Your later sweep appears to be normal now, yes. Discussed a bit recently also in another thread: /g/QRPLabs/topic/107485051#msg126409 -Nate N8BTR

I have a DIY power bank made with 3 x 18650 cells I use on SOTA. ?I charge it to 12V and not more. ?After about an hour long session it only drops the voltage to 11.5V. Next, I'm planning to move

Did not expect to be getting an ATNO DX on 3 Watts on 20 meters. Nice little rig. Mark W8GU

Just tried PTT test in diagnostics and get the same bias current fluctuation. I've tried various firmware versions - now on 0.26

I would like to branch into digital. Does anyone know if there is a "digital comms for dummies" or equivalent book that can explain it from the ground up to get started? -- Wayne S. KF7RCM

I have had the big one and the mini for a couple of years and luv-em'. Thing is, the audio on the mini is way better than its big brother. I know I can just use the mini, but I like to use them all.

Has anyone tried replacing the 3 BS170s with a single IR510? I have a uSDX using one that has been absolutely bulletproof. Maybe it is a unicorn, but it also gives 5 watts on 1Om. JS6TMW

Second vote for the Talentcells; I have 2 of them and rotate them. Very happy with them. Greg N1TR

I have this one .? Very pleased since it won't overvoltage the QMX * Talentcell Rechargeable 12V 3000mAh Lithium ion Battery Pack. *

What's a good battery to provide 12 V to a QMX or QDX for SOTA operation? I have a battery that I use for Field Day and other ops, but it weighs something like 30 lbs, and I don't think I want to

I ran into a similar issue of not restarting after upgrade to _026. It happened on a QMX and QMX+. They both stayed in USB drive mode showing both the _025 and _026 files. Could not turn either one of