开云体育

Hans, Now thats what I’m talking about! ?Love the way you think. I’m getting ready and calculating location of the PIR sensor. Some days she can move faster than others! ?I have to factor that

Great that you found out and shared it. But I'm surprised that this standard measure isn't included in the original design. Software hides many hardware problems, but it doesn't fix them. Keyword

Hi Dave Mmmmm, think you can add a sensor that warns me when the wife is heading Not currently, unfortunately. But I think the best way to do this would be wait for when the BASIC scripting language

Hello Chris, My inexpensive DVM shows 11mA at the supply voltage of 11.0V and 21mA at 20.3V. These values may not be very accurate, but the current consumption in the receive mode is very low –

Hi Roger There's a bug report open, that the "tip" and "ring" are reversed on the straight key setting. So for now try "ring" as the straight setting even though you've got a mono plug (means it

Hello from SM Mine drew 12 mA on receive when powered with 12.0 V. My build and test thread pn Mastodon: https://tilde.zone/@raek/112591872225951359 73 DE SA5RJS

I did a nice editing job on the MTL below? but? the rubbish GroupsIO software appeared to lose it. Go by stream of consciousness? I ma NOT going to waste more time on it - the original amp was

Looked for a while and can't seem to find an answer, so here goes: Is it possible send CW directly "live" on the QCX-mini with FLDigi and CAT? I suppose putting the macro string into QCX memory is

Mono plug may be contacting both tip and ring contacts inside the Q? Greg Yahoo Mail: Search, Organize, Conquer On Sat, Aug 3, 2024 at 8:47 PM, Roger Hill<rhill@...> wrote: Should

Should have said...mono plug. Roger

Hi All. Doing initial setup on my QMX+, FW23. Keyer set to straight, mode set to TIP, my key is permanently keying the rig. The same key works fine on my QCX+, same settings. Is anyone else

Hi Mark, it’s here http://shop.qrp-labs.com/qmxpdev

Ronan, Fantastic! It's been an annoying problem for me too. I am going to do this with mine too. -- 73, Dan? NM3A

I'd like to order a development kit for my QMX+ but I don't see anywhere I can order it by itself.? Any suggestions? Thanks... -- 73...? ? ? Mark? ? ?AA7TA

Hello from ZL What is the current consumption of the PA when it is in receive mode? I would like to set my current limit to just above that for the first power up ie pre key down. I don't want to

Thanks Hanns, You’re amazing, the QMX is amazing. Amazing what can be done with firmware changes. Did i say amazing enough!! Mmmmm, think you can add a sensor that warns me when the wife is

Wei, that sounds like a different problem but it seems you've solved it one way or the other. ?

QCX rot encoder resistors and capacitors

Hi, Ronan Thank you for sharing this, I remembered that QCX has 10k pull-up resistors and capacitors to ground like on image attached. It is quite interesting solution for QMX. May be chip has

Hi Ronan, Your post saved me. I have been struggling with a similar problem since I received my QMX last week. My QMX's symptom is to push left rotary(change mode/band) will freeze the QMX randomly.