开云体育

shoot oh well. Thanks for letting me know before I got into it! These devices are "Relatively" inexpensive. I'll procure a QMX and be super cautious this time. Best regards! ~Gordon

Not in my version, it wasn't! Added since I started building mine! ;-)

I was just doing that as you were writing. No go. Maybe with flux. But it won't be easy Sometimes the answer is considering the labor; "We need to replace the motherboard."

ChipQuick looks like a promising option https://youtu.be/UmD7F0--7Lc The idea is that it's a low melting point alloy that bonds to the solder lowing the overall melting point, thus buying you a bunch

Hi Wei Instead of "Shut Down!", is it possible to change it to "Shut Down?", then I added it to my list... 73 Hans G0UPL http://qrp-labs.com https://www.buymeacoffee.com/g0upl >

Hi George Which issue are you referring to? It isn't clear from the messages, who you are replying to... If the question is about the issue with 1_00_022, SWR and GPS tools didn't run on the QMX

Try getting a dead PC and experiment on the board. That's what I do. 73 Jim N6OTQ [email protected]> wrote:

Did this issue affect the QMX+ as well? I must not understand the problem HiHi.

Thank you Greg. I have seen enough posts in the past to presume as time goes by we may see more. I like the wire idea.

Hi Jim I am not sure if functionality has changed or if your recollection is entirely correct, or some combination of both. Certainly RIT never moved in 50Hz steps. 1k, 500Hz, 100Hz and 10Hz. But

David, Can you be sure the spectrum analisers are accurate? It is best to measure the U3S oscillator, is it TCXO? If it is it should not be far out. If is not then somewhere in the manual is an

Hans, We're ready for SSB. 73 Jim N6OTQ [email protected]> wrote:

Hello David I suggest checking this first: https://qrp-labs.com/faq.html#cal 73 Hans G0UPL http://qrp-labs.com https://buymeacoffee.com/g0upl [email protected]> wrote:

Hans, Excellent, such a unique way of updating! Thanks and 73

I found an app note on biasing of quantum Qubits.? This reads much like some of our discussion of QRP-Labs products.? The smaller things get, the more the issues stay the same. Introduction

recently completed a U3s WSPR kit.? Included in my build was the LPF kit, QLG1 GPS kit and the enclosure. All seems to be working, GPS locks in sets time, location, etc.? I currently have it set to

Mis-typed. Can now only tune in 1Khz, 500 Hz, or 100 Hz steps. Used to allow 50 Hz steps AND the RIT was saved by double clicking the left button. -- Jim / K7TXA Eagle, ID SKCC 10447T BUG 301

Hi Hans, Instead of "Shut Down!", is it possible to change it to "Shut Down?", then use "select" to confirm and "exit" to cancel. It happened quite often that I meant to change mode/band, but end up

I'm on firmware xxx.23 on my mid band QMX, but also noticed this on xxx.20 - When I bring up the RIT display, it shows +0.000. I can toggle between the +0, the "." and the leftmost of the three zeros.

Hi Joe Not the way it works... QMX only pretends to be a USB flash drive. It's extremely minimal. Bootloader, USB stack, FAT16 file system, 256-bit encryption, I2C EEPROM and the Flash programming